ROSETO HMIF98135GOCHRY Oak Cherry Elden 43 Inch 4 Shelf Hardwood Curio Cabinet Installation Guide
- June 15, 2024
- ROSETO
Table of Contents
ROSETO HMIF98135GOCHRY Oak Cherry Elden 43 Inch 4 Shelf Hardwood Curio
Cabinet
INSTALLATION INSTRUCTION
SOME NSTRIETDNS AND 1 OR PARTS NOT APPLY TO YOUR PARTEIJLAR MODEL
- NOTE: BEFORE INSTALLING THE GLASS SHELVESWE RECWMEND THAT YOU SECURE THE UNIT TO THE WALL AFTER POSITIONING THE UNIT IN THE DESIRED LOCATION.
- ON ALL CURIOS: THE ATTACHED WALL HANC,r, BRACKET(S WILL ALLOW THE UNIT TO BE SECURED TO THE WALL. AND WILL HELP PREVENT OF THE UNIT.
NOTE:
- SOME CURIOS HAVE THE DOOR HARDWARE SHIPPED OFF THE UNIT AND PLACED IN A BAG INSIDE FOR SHFQING PURPOSES AND MUST BE INSTALLED BY THE CUSTOMER
- TO INSTALL: ALIGN HARDWARE ON THE OUTSIDE OF THE DOOR THEN USE A STANDARD SCREWDRIVER TO TIGHTEN UP THE ENCLOSED SCTRW(S).
- REMOVE RUBBER BANCS FROM THE LIGHT FIXTURE AND TWIST-TIE WIRE FROM AROUND THE POWER CORD. RUN CORD THROUGH EXIT HOLE IN FURNITURE AND INSTRL ENCLOSED HCLE PLUG IN9DE THE UNIT.
- NOTE: IF YOUR CURIO IS EQ WITH A LOCK ON THE DOOR, THE KEYS ARE TAPED TO THE OUTSIDE OF THE CASE.
- NOTE: I Y UR NEW PEDUTH L OUTLETS ON THE I-PRO-IT RALS, IFDE THE CASE IF ANY OF THE OUTLETS DO NOT FUETION PRTERLY AFTER SHNENT. PLEASE CHECK coteæcnms BETWEEN THE OUTLETS FOR TIGffNSS. THEY ARE ON THE OF THE CASE.
FOR SOME SIDE ENTRY GLASS DOORS
NOTE:
- THE DOOR PUL LS ARE SHM)ED REVERSED (TURNED TO THE INSIDE.
- TO OPEN DOORS PULL THE TAPE THAT IS ATTACHED TO THE.
- TOP DOOR AND OPEN. REACH INSIDE AND PUSH BOTTOM DOOR OPEN.
- AFTER THE DOORS ARE OPEN REMOVE THE BRASS PULLS FROM THE GLASS DOOB AND ROTATE THEM SO THAT THE CASPNG LP IS FACING TO THE OUTSIDE (AS SHOWN ABOVE) THEN REPLACE THE DOORS.
- UPON COM REMOVE THE TAPE FROM THE DOOR.
- IF THE UNIT HAS GLASS DOORS, THEY CAN BE ADJUSTED OR REMOVED BY LOOSENING ADJUSTMENT SUREWS ON HINGE.
- ( CAUTION: DO NOT OVERTIGHTEN)
NOTE: BEFORE YOUR POWER CORD INTO THE ELECTRICAL SUPPLY, REMOVE THE END
CAP OF THE LIGHT FIXTURE BY PRESSING THE TWO BOTTOM FLANGES TOWARD EACH OTHER
UNTIL THE END CAP CAN BE PULLED OUT, SHOWN. THEN REMOVE THE CARDBOARD
PROTECTOR FROM THE BULB THE END CAP CAN BE REPLACED BY AGAIN PRESSItr, THE
FLANGES TOGET HER UNTIL THE CAP FITS OVER THE SHELD TO CHANGE THE LIGHT BULB,
FOLLOW THE SAME PROCEDURE AS ABOVE TO REMOVE AND REPLACE THE END CAR
NOTE: LIGHT IS CONTROLLED BY A TURN THE SWITCH ON THE FIXTURE.
IMPORTANT LIGHT INSTRUCTIONS
IMPORTANT LIGHT INSTRUCTIONS FOR CERTAIN UNITS
WARNING:
- The canister light gets hot. Do not place anything on top of the canister light.
- The intended use of this fishing is for indoor household furniture.
- A.’0id contact with the cord prongs.
- A/0id contact of combustibles such as plastic, paper goods, and similar materials with the lamp, lamp holder, and reflector.
- The luminaire is not intended for illu mination of aquariums.
IMPORTANT SAFETY INSTRUCTIONS
- When using an electrical furnishing, basic precautions should always be followed, including the following:
- Read all instructions before using this furnishing.
DANGER – To reduce the risk of electric shock:
- AWays unplug this furnishing from the electrical outlet before cleaning.
WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons:
- Unplug from the outlet before putting on or taking off
- Cbse supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
- Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
- Never operate this furnishing if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
- Keep the cord away from heated surfaces.
- Negter operates the furnishing with the air opening blocked. Keep the air openings free of lint, hair, and the like.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where are being administered.
- To disconnect, turn all controls off then remove the plug from the outlet.
- For loading, always put heavier items at the bottom and not near the top to help prevent the possibility of the furnishing tipping out.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>