SUPER73 Folding Static Pegs Instructions
- June 15, 2024
- SUPER73
Table of Contents
SUPER73 Folding Static Pegs
Product Information
Specifications
- Product Name : Static Pegs
- Compatibility : Bike models with peg attachment holes near the rear wheel
- Materials : Metal
- Weight : N/A
- Color : N/A
Product Usage Instructions
-
Step 1: Bike Preparation
Ensure that the bike is stable and turned off. -
Step 2: Locating Peg Attachment Holes
Locate the peg attachment holes on each side of the bike frame near the rear wheel. -
Step 3: Attaching the Static Pegs
Take one socket head screw and slide a flat washer onto it.
Insert the screw into one of the peg holes from the inside of the frame. -
Step 4: Aligning and Tightening
Ensure that all components are aligned properly.
Use a 0 mm hex wrench to tighten the peg into place securely. -
Step 5: Repeat for the Other Footpeg
Repeat steps 4 to 7 for the other footpeg.
Frequently Asked Questions (FAQ)
- Q: Where can I find additional support?
A: For further assistance, you can visit our support website at support.super73.com.
STATIC PEGS INSTALLATION
Caution
- The peg attachment is located near the rear brake rotor. DO NOT install immediately after riding as the brake rotor will be hot and could potentially burn you.
- When using footpegs, refer to your bike’s user handbook and do not exceed the maximum recommended weight limit for your bike of 325 lbs.
- Avoid touching the brake rotor during installation as the oils on your hand will contaminate the rotor and cause it to squeak when in use.
Included Materials
- Static Peg (x2)
- Anti-Rotation Bracket (x2)
- Socket Head Screw- M˜2 x ˜.25mm Thread, 20mm Long (x2)
- 18-8 Stainless Steel Washers for M˜2 Screw Size, ˜3mm ID, 20mm OD (x2)
Tools Required
10mm Hex Wrench
Installation Instructions
- Start with the bike stable and turn it off. Locate the peg attachment holes on each side of the frame near the rear wheel.
- Slide one flat washer onto one of the socket head screws then insert the screw into the peg hole from the inside of the frame.
- Hold the washer and bolt in the hole, feed the following components onto the screw in this order
- 1 anti-rotation bracket with the tab positioned under the attachment hole.
- Flat washer
- The footpage can be installed and hand-tightened until the hex wrench is needed.
- Now that all of the components are aligned, use the ˜0 mm hex wrench to tighten the peg into place.
VISIT SUPPORT.SUPER73.COM FOR HELP
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>