SINVANHO 60784 Car Cup Holder Expander with Phone Mount Installation Guide
- June 15, 2024
- SINVANHO
Table of Contents
2 in 1 Car Cup Holder with Phone
Mount
Install Instruction:
Put the threaded ring through the ball.
Snap the ball into groove on the back of the holder.
Tighten the nut clockwise onto the back of the holder
Put base in cup holder, then twist knob to fit.
Twist the two knobs on the neck and turn the bottom famly to adjust the angle
Press the button to release phone holder and put phone on it
Warm Tips:
-
If you want to rotate the entire bracket bar, hold the bracket bar at the bottom and turn it firmly in a counterclockwise direction.
-
If your cup is too big and hard to get it out, you can try cutting off the soft rubber tabs.
-
If you have adjusted the base of the cup holder to the maximum diameter, and it’s still not stable enough, you can put the 3 gripper caps on and try again.
-
When installing the phone holder, you only need to push the bail hard to the back of the phone holder and then tighten the plastic ring, no need to use other tools.
If you need more information or help with this product, please feel free to
contact us, our after-sales email is
YizeO322us@i63.com 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>