ZENBED STARLIGHT-GALAXY Galaxy Projector User Manual

Table of Contents

Check for the contents in the package refers to the following list:

Input power: 5V2A
Output power: 5V0.5A(USB interface)
Laser Power: 30mW 515nm green
LED Power: red: 1W, green: 1W, blue: 1W
Housing material: ABS
Application: Home light.Party light.Atmosphere light.Bedroom, Night light.Theater, Restaurant.Bar etc

Before the network is configured, make sure that the phone cannot be connected to any Bluetooth devices, including the internal speaker of the lamp, but after the network is successfully configured, it will not affect the connection of the Bluetooth devices.
If the light leaves the WiFi range of the router or if the router is turned off, the light will automatically enter Bluetooth control mode within 5 minutes and continue to operate normally.
In the Bluetooth control mode, it can connect to bluetooth devices, such as bluetooth speakers, it’ snot affected.

Setting up the projector as a bluetooth speaker

The Bluetooth feature of the projector is turned ON by default,and you will hear a voice prompt saying,”Bluetooth Mode”when you turn ON the projector.
Now.turn ON the Bluetooth on your smartphone,tablets,computer, or other devices.and set it to search for a new device.
Select the “Galaxy Starship” from the list of devices.
Once paired,you will hear a voice prompt”The Bluetooth device is connected successfully.

ZENBED-STARLIGHT-GALAXY-Galaxy-Projector-2

Short press: turn on/turn off.
Long press: press the button for more than Ss until blue lighting up to get distribution network.
Continuous short press: cycle through multiple scenarios in sequence.
Continuous short press: cycle through multiple music rhythms in sequence.
Short press: previous song.
Long press: volume down.
Short press: next song.
Long press: volume up.
Short press: Play/Pause.
Long press: Bluetooth Connected/ Bluetooth Disconnected.

Instruction on Smart APP connection with Aurora Projector.

Open “Location Based Service” and “Bluetooth Speaker” in your Mobile Phone;
Download “ TuyaSmart” in Mobile App Store;
Reglster an account In wTuyaSmart” (choose “Sign up” );
Open Galaxy Starship Projector Light, Keep pressing on—off key ( *s), click + in TuyaSmart, and add Galaxy Starship to enter “Add Manually”
Choose “Auto Scan” to find “Galaxy Starship” , click “Next” 10 connect yourWiFi, and then press “Confirm”
Appearing “Connecting … ” (100%) means having finished the whole connection. (Note: Wifi router.mobile phone and Aurora Projector need to be put together.)
Click “Done” , and automatically enter into “Profiles” : you can freely select profiles, or create personal profiles.

Instructions on the buttons of the SmartApp:

ZENBED-STARLIGHT-GALAXY-Galaxy-Projector-15