ROSETO HMIF65289 Hardwood Curio Cabinet with Puck Light Instruction Manual

ROSETO HMIF65289 Hardwood Curio Cabinet with Puck Light

Revised 2011-8-29

• NOTE: BEFORE INST /UNG THE GLASS SHELVES. WE  RECOMMEND THAT YOU SECURETHE UNIT TO THE WALL AFTER POSITION NG THE UNIT IN THE DESRED LOCATION.

• ON ALL CURIOS: THE ATTACHED WALL HANG! BRACKET(Sl WILL ALLOW THE UNIT TO BE SECURED TO THE WALL AND WILL HELP PREVENT TIPPNG OF THE UNIT.

• NOTE : USE ADJUS ABLE GLOES TO LEVEL DOORS A ER SET-UP.

• DOORS BY GLIDES UP OR DOWN UNTIL DOORS ARE LEVEL AT THE TOP AND BOTTOM. ALSO USE TO LEVEL UNIT ON UNEVEN FLOORS.

• THE OOOR PULLS ARE SHPPED REVERSED (TURNED TO THE INSIJE)

• TO OPEN OOORS PULL THE TAPE THAT IS ATTACHED TO THE TOP OOOR AND OPEN. REACH INSDE AND PUSH BOTTCt.l DOOR OPEN.

• AFTER THE DOORS ARE OPEN REMOVE THE BRASS PULLS FROM THE GLASS DOORS AND ROTATE THEM SO THAT THE GAASPNG LP IS FACING TO THE OUTSDE (AS SHOWN ABOVE) THEN REP

• LACE ON THE DOORS.

• UPON COMPLETICJl, REMOVE TAPE FROM DOOR

DJUSTMENT Sinews
IF THE UNIT HAS GLASS DOORS, THEY CAN BE ADJUSTED OR REMOVED BY LOOSENING ADJUSTMENT SCREWS ON HINGE. (CAUTION: DO NOT OVERTGHTEN)

Curios and Consoles

• SOME IISTROCTIONS AND/ OR PARTS MAY NOT APPLY TO YOUR .AR MODEL
• IF SUPIED, USE A SCREWDRIVER AND THE SCREW PRD\4DED TO ATTACH THE SHELF SUPPORT TO THE INSDE DF THE CURIO.

NOTE

• SOME CURIOS HAVE THE DOOR HARDWARE SHPPED OFF THE UNIT AND PLACED IN A BAG INSIDE FOR SHPPING PUWOSES AND MUST BE INSTALLED BY THE CUSTOMER

• TO INSTALL: ALIGN HARDWARE ON THE OUTSIDE OF DOOR THEN USE A STANDARD SCREWDVER.

• Some lights are controlled by an On/ Off switch that is located on the cord. Roll the wheel forward to turn the light On or Off.

• Some lights are controlled with this switch that has High, Low, and Off settings.

• The holder can be taped to the left or right back of the Curio.

• REMOVE RUBBER BANOS FROM LIGHT FIXTUREAND TWIST -TIE WIRE FROM AROUND POWERCORD. RUN CORD THROUGH EXIT HOLE IN FURNITURE AND INST/U ENCLOSED HCl.E PLUG INSIDE THE UNIT.

• NOTE : BEFORE PLUG YOUR POWER CORD INTO THE ELECTRICl SUPPLY, REMOVE THE ENO CAP OF THE FIXTURE BY PRESSING THE TWO BOTTOM FLANGES TOWARD EACH OTHER UNTIL THE END CAP CAN BE PULLED OUT, AS SHOWN.THEN REMOVE CARDBOARD PROTECTER FROM THE BULB. THE END CAP CAN BE REPLACED BY AGAIN  THE FLANGES

• TOGETHER UNTIL THE CAP FITS OVER THE SHELD. TO CHANGE THE LIGHT BULB, FOLLOW THE SAME PROCEDURE AS ABOVE TO REMOVE ANO REPLACE THE ENO CAP.

• NOTE: LIGHT IS CONTROLLED BY A TURN SWITCH ON FIXTURE

GLASS SHELF REMO/AL INSTRUCTIC FOR CURIOS WITH GLASS SHELVES SHPPED INSIDE

• TO REMOVE SHELVES FROM INSIDE THE UNIT USE A STANDA RD SCREWDRIVER
• TO TURN THE SHIPPING PINS 180 DE GRE ES (AS SHOWN ABOVE)THEN PULL FROM HOLE.
• WARNING : The canister light gets hot. Do not place anything on top the canister light.
• The intended use of this furnishing is for indoor household furniture.
• Avoid contact with the cord prongs.
• Avoid contact of combustibles such as plastic, paper goods, and similar materials with the lamp, lamp holder and reflector.
• The luminaire is not intended  aquariums.

IMPORTANT SAFETY INSTRUCTIONS

• When using an electrical furnishing, basic precautions should always be followed, the following
• Read all instructions before using this furnishing.
• DANGER – To reduce the risk of electric shock

1. Always unplug this furnishing from the electrical outlet before dealing.
   WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons

2. Unplug from outlet before putting on or taking off parts.

3. Close supervision is necessary hen this finishing is used by, or near children, or disabled persons .

4. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.

5. Never operate this funishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
   Keep the cord away from heated surfaces.

6. Never operate the furnishing with the air opening blocked. Keep the air openings free of lint, hair, and the like.

7. Never drop or insert any object into any opening.

8. Do not use outdoors.

9. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.

10. To disconnect, tum all controls to the off position, then Remo,, e plug from outlet.

11. For loading, always put heavier items at the bottom and not near the top I order to help prevent the possibility of the furnishing tipping

12. WARNING – Risk of Injury to Persons – do not place video equipment such as televisions or computer monitors on shelves.

13. WARNING – Risk of Injury to Persons – do not use this furnishing equipment such as televisions or computer monitors.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>