PROEMION 3000 CANlink Mobile Telematic Device User Guide
- June 15, 2024
- PROEMION
Table of Contents
PROEMION 3000 CANlink Mobile Telematic Device
The Migration Guide for the Signal Catalog describes how to migrate the signal definition from the definition in PDCs to a unique definition on the Data Platform.
Migration Guide for the Signal Catalog
The Signal Catalog enables the editing of signal definitions used across the organization’s fleet.
In addition, you can now migrate all the currently applied signal definitions from the machines’ PDCs to the Data Platform, resp. Data Portal, which allows you to edit the (repeated) signal definitions for all machines at once.
Beforehand, identical signal definitions used by several machines could only be edited separately in each PDC of a machine, leading to redundant work and conflicts.
In the following it is described how to migrate the signal definitions to the Signal Catalog.
Requirements
-
The permission set Models: Admin, see Models Subject, for the Data Portal is needed for the migration of the signal properties.
-
Signal definitions are stored at the tenant.
The user must be a member of a tenant organization, read Tenant. -
Only valid signal definitions are considered. That means:
- Without any conflicts.
- Using a predefined unit (custom units are not supported).
- Must be bound To: machine (not model).
- Standard signal, i.e. must be present in the standard Signal Catalog.
- Or custom signal must use the prefix value.*
In the Data Portal, signal definitions are not strictly validated according to the Proemion Standard Metrics.
Migrate signals
Migrated signals cannot be deleted.
You can individually migrate signal definitions to the Signal Catalog or
perform a mass migration.
The Signal Catalog table shows you in the Catalog column whether a
signal key is “Not in Catalog”.
It also indicates “Conflicts” within signal definitions in case there any.
The View summary toggle will show you the total number of the signals
“Without conflicts”, “In Catalog” and “Use standard metric key”.
Migrate all signal definitions
-
Open Settings > Machine Data Management > Signal catalog.
-
Click Migrate signals to catalog in the upper-right corner.
The button is not shown when all signals have been already migrated. -
Confirm the dialog window that displays the number of the signals to be migrated.
✓ When the signal definitions are valid, i.e. met the Requirements, the
success message shows the number of the successfully migrated signals.
In the Signal Catalog table they will get the label In Catalog and can now
be managed in the UI, see View and Edit or Delete Signal Details.
Migrate specific signal definitions
-
Open Settings > Machine Data Management > Signal catalog.
-
Click View Signal Details by the end of the row of the desired signal key.
The details page opens:
-
Click Migrate to catalog in the upper-right corner.
When the signal key is not eligible to migrate, i.e. does not meet the Requirements, the button is greyed out:
-
Confirm the dialog window that to start the migration.
✓ A success message indicates the successful migration. In the Signal Catalog table the signal key has then the label In Catalog.
Version: 11.0.497
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>