ewent EW1700 Portable Device Management Cart Cabinet User Guide

ewent EW1700 Portable Device Management Cart Cabinet User Guide

Safety and Warnings

CAUTION

• Toreduce risk of electric shock only use this product indoors.

• This product is heavy. Use caution handling and keep upright. Do not attempt to unpack or move it unassisted.

• Use caution when unpacking and save the packing material for later use. Scratches and other damage caused by mishandling is not covered by the warranty.

• Do not allow anyone to sit, stand, or climb on this product.

• Do not block the ventilation holes used for air circulation.

• Do not overload heavy objects on or inside this product.

• Before moving this product, disconnect the power from the wall outlet.

• While moving this product, make sure the power cord issecured.

• This product should always be used by adults or with adult supervision.

• Never unplug this product from the outlet when hands are wet or by pulling the power cord.

• Do not use an extension cord in conjunction with this product.

• Connection to any other type of receptacle other than a two-pole, three-wire grounded receptacle may result in shock hazard as well as violate local electrical codes.

• In the event of an emergency, disconnect the power cord from the AC power outlet.

• Do not plug the input of this product into its own output.

• Do not attach an additional extension cord, power strip, or surge protector to this product.

• Do not attach non-computer-related items, such as medical equipment, life-support equipment, microwave ovens, or vacuum cleaners to this product.

• Place cables in such a way that they won’t be pulled or snagged, and no one can step on or trip over them.

• Do not attempt to disassemble this product. This product contains no user replaceable parts. Only factory service personnel may performrepairs.

• If this product is misused, incorrectly operated or repaired, the warranty will be void.

• Do not remove plugs from outlets in use labeled “Do not remove” with a red sticker. These are required for the charging system and auxiliary outlets of
  the cart to function.

• Service Door – Please open only if requested by Ewent Technical Support.
  

GETTING STARTED

Package includes

• AC Power Cord

• Keys

Cart Diagram

**Front

**

Remove from pallet

1. Lift Handle Open Doors

2. Turn left or right to open

Door Locks

Front/Back

SETUP

1. Plug cart into outlet
   

2. Plug in AC Adapters
   

3. Place adapters into power supplyholders
   

4. Insert the adapters through the passthrough holes
   

5. Place the adapter wires on the cable holder dividers
   

6. Place the devices in the dividers
   

Charging System

Charging System

Charging all of your devices at one time can overload a typical circuit. EwentCharge Carts are equipped with an intelligent timing device that automatically switches the AC power supply from one half of the device outlets to the other to help protect against overload.

The charging system will provide power to the first half of the outlets for 15 minutes. When that time expires, the cart will change power to the other set, and continue to alternate
sides. Once the total current is less than 14 amps, it will power all the outlets at once.

The LED indicator on the outside of the cart will show you which set is currently charging

than 14a, full charging starts
LED Indicator| Red (On): Charging
Off: Not Charging
Time to Charge 36 Computers| 4.5 hours
Cart Switches to Full Charging| After 6 cycles (~3 hours)

TECHNICAL SPECIFICATION

Cart Dimensions

EW1700

Color| Black and Dark Gray
Material| High-grade 18 gauge cold rolled steel
Numbered Device Spaces| 30
Organization and convenience| Flexible device dividers with cable channels and num­bered device slots, numbered power adapter slots with cable management, recessed push handle
Warranty| 5 Year
Package Contents| Charging Cart, 6 ft (1.83 m) Power Cord, Manual
Input Voltage| 230VAC, 15A, 60HZ
Output Voltage| 230VAC, 15A, 60HZ
Charging System| Intelligent Charging
Rolling Casters size| 5 in (12.7 cm)
Product Dimensions| 600 x 580 x 1127 mm
Product Weight| 75kg
Package Size| 650 x 650 x 1280 mm
Package Weight| 90 kg
Device slot dimensions| 16.61 x 1.38 x 11.25 in (422 x 35 x 286 mm)
Power adapter slot dimensions| 3.07x 18.22 x 4.48 in (78 x 463 x 114mm)
Safety & Compliance| CE,ROHS,FCC
Environment*| “Operating: -10°C to 40’C Humidity: 20%to 80% RH Storage: -40°C to +60°C Humidity: 20% to 90%RH”

Note: For this charge cart only. Check the environment specifications ofthe devices you are storing.

References

• Ewent Eminent |
• Ewent Eminent |

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>