VEROBOARD 24VB 12MM 6 Wires To Strip Quick Connector Installation Guide
- June 15, 2024
- VEROBOARD
Table of Contents
VEROBOARD 24VB 12MM 6 Wires To Strip Quick Connector
Product Usage Instructions
Step 1: Cut and Strip Light
- Identify the cutting point on the light tape.
- Using appropriate tools, carefully cut the light tape at the designated cutting point.
- Strip the ends of the wires to expose a small section of bare copper.
Step 2: Insert Light and Wires into the Connector
- Take the strip light and align the stripped ends of the wires with the connector pins.
- Insert both the strip light and wires into the connector at the same time.
Step 3: Close the Connector
- Push both caps of the connector firmly until they snap into place.
- Ensure that the connector is securely closed to prevent any loose connections.
Note
- Make sure to follow the correct polarity (positive and negative) when inserting the wires into the connector to ensure proper functionality of the strip light.
Important Note
- This connector is designed for use with a maximum light tape length of 10ft (3 meters).
- Exceeding this length may result in performance issues or damage to the connector or strip light.
Frequently Asked Questions
Frequently Asked Questions (FAQ)
- Q: What is the maximum amperage supported by this connector?
- A: This connector supports a maximum amperage of 12V – 5A or 24V – 4A.
- Q: What wire gauge is compatible with this connector?
- A: This connector is compatible with 22 AWG wire gauge.
- Q: Can I use this connector with a different size of strip light?
- A: No, this connector is specifically designed for use with 12mm strip lights. Using it with a different size may result in improper connections or damage to the connector.
- Q: Can I extend the length of the strip light beyond 10ft (3 meters) by using multiple connectors?
- A: It is not recommended to exceed the maximum supported length of 10ft (3 meters) even with multiple connectors. Doing so may cause performance issues or damage to the strip light and connectors.
Specification
- Max. Amp: 12V – 5A / 24V – 4A
- Wire Gauge: 22 AWG
Using Instructions
- CUT STRIP LIGHT AT CUTTING POINT
- INSERT STRIP LIGHT AND WIRES INTO THE CONNECTOR AT THE SAME TIME
- PUSH BOTH CAPS TO CLOSE THE CONNECTOR
Use this connector for a maximum light tape length of 10ft (3 meters)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>