MAXTRA Gas Powered Pole Saw Instruction Manual

MAXTRA Gas Powered Pole Saw

Specifications

• Spark Plug: Provided tool

1. Take off the spark plug, with the provided tool

2. Check whether the spark and engine plug is wet.
   Tips : use this tool to take off

3. After steps 1 and 2, if the spark and engine are dry, you need to add more fuel; maybe the amount of fuel is too low. If it’s wet, then maybe Engine flooded cylinder, so you need to do:

4. Clamp the inlet pipe with a tool (Avoid more fuel adding in the cylinder) , turn on the throttle , and pull the starter to release the excess fuel, Pull more than 10 times

5. Install the spark plug and loosen the inlet pipe to start the engine again

TIPS: VERY IMPORTANT!!!

1. Do not press the fuel pumper more than five times to avoid too much fuel into the cylinder
2. When the throttle in the off state, please do not pull the starter more than 7 times or excess fuel may into the cylinder. If the engine can’t start within 7 times,
   please turn on the throttle and wait for 5 minutes to try again

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>