noorio H200 Contact Sensor Alarm Door Window User Guide

: June 14, 2024
: noorio

Table of Contents

noorio H200 Contact Sensor Alarm Door Window
What’s Included
Product Overview
LED Indication
Battery Installation
Set Up Your Device
Notice
ISED Statement
Customer Service
Read User Manual Online (PDF format)
Download This Manual (PDF format)

noorio H200 Contact Sensor Alarm Door Window

What’s Included

Product Overview

LED Indication

LED Light Sensor Status

Flashing blue: Ready for setup
Flash blue once: Contact sensor open/close

Battery Installation

Open the back cover of the sensor and take it off.
Install the CR123A battery into the slot correctly.

Set Up Your Device

Scan the code below to get the Noorio app.
Tap “Set Up a Device” to add your sensor.

For online help and support, visit https://support.nooriolife.com/

Notice

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.

Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements.
The device can be used in fixed/mobile exposure condition. The min separation distance is 20cm.

This product complies with the radio interference requirements of the European Community.

Declaration of Conformity
This product complies with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit https://www.nooriolife.com/

Battery Safety (Only for the product has batteries)
Do not expose the device to fire, explosion or other hazard. Do not use the device in the environment at too high or too low temperature, never expose the device under strong sunshine or too wet environment. Do not charge the battery.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

ISED Statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

This device may not cause interference, and
This device must accept any interference, including interference that may cause undesiredoperation of the device.

The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.