Smgboida B0CGPXC3ZJ LED Video Light User Manual
- June 14, 2024
- Smgboida
Table of Contents
Smgboida B0CGPXC3ZJ LED Video Light
Preface
Thank you for choosing the LED video fill light.
It is hoped that you can know the use of the product clearly and conveniently
through this manual, If you have any questions or suggestions, please contact
us.
Reminder
- When using this product, please use a SVlA USB charger to charge the device.
- This product adopts a built-in lithium battery. It is forbidden to disassemble, impact, squeeze or put it into fire. In case of a serious bulging of the battery, please cease using the product.
- When using the product, please avoid dripping water or other liquids into the device, to prevent causing a short circuit and device damage.
- Do not use the LED fill light near chemicals, combustible gases or other special substances, which may cause fire or electromagnetic interference. Under the above circumstances, please pay attention to the relevant warning signs;
- Do not disassemble the device by yourself, which may cause damage to the product when touching the internal parts of the product.
Product Introduction
-
LED fill light
-
1/4″ screw adapter
-
Cold shoe adapter
-
Adaptive angle-adjustable clamp
-
Filter Frame
-
Filter
-
Charging cable
-
Instructions
Product Description
Product Usage
This product has three installation methods
Method 1: Use a clamp to fix it on a mobile phone, tablet or laptop and
other objects.
- Insert the part with a snap at the top end of the clamp into the insert hole of the main light.
- Turn the knob to adjust the light to the angle you need.
Method 2: Use the 1/4″ screw adapter to fix the light on the light holder.
- Insert the 1/4″ screw adapter into the insert hole of the light
- Align the 1/4″ screw hole with the light holder and rotate to fix it.
Method 3: Use the 1/4″ screw adapter and cold shoe adapter to install the light on the camera.
- Insert the 1/4″ screw adapter into the insert hole of the light.
- Screw the nut end of the cold shoe adapter into the screw hole of the 1/4″ screw adapter.
- Insert the cold shoe adapter base into the cold shoe port of the camera.
Remove the clamp or adapter
Press the snap with the tips of your thumb and pull out the clamp or adapter
outward.
Usage of filter
- Align the slot side of the filter frame with the key surface of the video light and cover it on the video light.
- Insert the filter into the slot of the filter frame.
Remove the filter frame
Pull the two sides of the filter frame with your fingers.
Product Parameter
| Parameter | Description |
|---|---|
| Power | 4W |
| Number of LED light beads | 84 |
| Color temperature | 250 Lux/0.5m |
| Color rendering index | 3,000K-70,000K, white, yellow, Bi-color light |
| Brightness level | CRl ≥ 95 |
| Brightness level | 5 levels of brightness adjustable |
| Battery capacity | 3.7V 2000mAh |
| Usage time | Last for 2-2.5 hours in the brightest state |
| Input voltage | DC 5V 1A |
| Operating tern perature | -10 ° C~60 ° C |
| Dimensions of light body | 906575mm |
| Light bodyweight | Approximately 63g |
Customer Support
After-sales E-mail:Smgboidavip@ouUook.com
Scan code to active the warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>