Classy Caps SSL810 Solar Security Street Light Instruction Manual
- June 4, 2024
- Classy Caps
Table of Contents
Classy Caps SSL810 Solar Security Street Light
Lighting Instructions
How Your Solar Powered Street Light Works
-
The solar panel converts sunlight energy into electricity during the day. The FIG 1 photocell automatically turns the light on at night with the electricity stored in
the batteries. It requires no wiring, because it runs off the sunlight energy to
recharge the batteries so there is no cost to run the solar fixture. -
The number of hours the light stays on depends on your geographical location, weather conditions and seasonal sunlight availability. Allow 24 hours for the fixture to fully charge. Avoid placing the fixture by other light sources, as this may cause the solar light to turn off automatically.
Includes:
- 1 – Solar Light Fixture
- 1 – Wall Bracket & Post Mount
- 1 – Installation Accessories
- 1 – Remote Control
Installation
-
Loosen four nuts on the end of the lamp body, put the post of wall bracket into the lamp body, then retighten four nuts and press the green switch to “ON.”. – Fig. 1. Wall Mount: Choose your desired location. The 4 holes on the wall bracket
can be used as a template to mark the correct location. -
Drill 5/16” holes deep enough to accommodate mounting anchors. – Fig. 3
-
Attach the light fixture to the mounting anchors as shown (Fig. 3). Secure by tightening the nut on to the anchors clockwise.
Pole Mount: Install the light fixture to the pole using included pole bracket and mounting bolts. – Fig. 4
Remote Options- Turn the switch to ON. The light fixture will turn on to 100% brightness, after approximately 30 seconds the light will turn to 50% brightness. When the motion sensor is activated, the light will return to 100% brightness. – Fig. 2
- Push the corresponding button to activate the light from 25%, 50%, 75%, 100% brightness (continuous). – Fig. 2
- Timer Function: Push the corresponding button to activate the light from 2 hours, 3 hours, 5 hours, 6 hours, or 8 hours at 100% brightness. After the time elapses the light will turn to 50% brightness. When motion is detected, the light returns to 100% brightness for approximately 30 seconds. – Fig. 2
To Replace The Battery
- Unscrew the battery cover located on the bottom of the solar light fixture. – Fig. 5
- Replace the battery with a new rechargeable battery of equal capacity. Ensure the polarity is correct.
- Allow the fixture to receive a minimum of 24 hours of sunlight to allow the rechargeable battery to reach maximum capacity.
Troubleshooting
If the light does not turn on at dusk after 24 hours of charging:
- Check the battery to make sure it is making secure contact with the terminal.
- Be sure the solar panel is in a relatively sunny location.
- Make sure the solar panel is not affected by other light.
Maintenance
Periodically clean light fixture with soft cloth and warm soapy water.
One Year Limited Warranty
This product is warranted to be free from defects in workmanship or materials
at the time of purchase for one year,
(excluding batteries). Should a defect occur, please contact our customer
service line at 1-866-460-4604 for
service. Should any evidence of defects in material or workmanship appear
within the warranty period after the date of purchase, Classy Caps Mfg. Inc.
will either repair or replace the product at its option. Classy Caps Mfg. Inc.
is not responsible for injury, property damage, or other consequential damages
or damages to third parties arising directly or indirectly from an actual or
alleged defect in material or workmanship of the product.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>