WITMYA WT-ST-TC-02 Bidet Built In Intelligent Toilets Instruction Manual
- June 14, 2024
- WITMYA
Table of Contents
WITMYA WT-ST-TC-02 Bidet Built In Intelligent Toilets
Thank you
- Thank you for choosing our product. please read the instruction carefully before installation.
- To ensure that timely service is available for you, please keep the manual for future reference.
Package Contain
Remote Controller
CONTROL PANEL FEATURES
- Stop
- Rear/move
- Front/move
- Dryer
- Clean
- Forward
- Flush
- Backward
- Clean
- Bubbles
- Flip seat
- Flip top cover
- Wind temperature
- Seat temperature
- Water temperature
PRODUCT INSTALLATION
Construction Points and Names of Departments
The picture is shown In Figure 1. This picture shows the main components and construction points in the construction.
Preparation before Installation
User-supplied tools: adjustable wrench, wood working spirit level, Philips screwdriver, glass glue gun, glass glue. raw material tape, tape measure, right angle ruler, electric drill, drill brt
lnstallation steps
Mari< the center line a the drain on the drain, end Install the water Inlet
at99 val11e et a suitable position on
the Wal according to the size cl the toilet.
- install the water inlet angle valve (see Figure 1 )
- COns11uc11on and installation instruction (see Figure 2, Figure 3. and Figure 4)
- Align the wall with the centerline of the chin p1pe (there are two options: 305rml and 400mm).
- Draw the position of the center hole (select the installation hole according to the actual needs).
- Gently tum the toilet sideways. and press the side of the accessory seal ring with mud to the sewage drain at the bottom of the toilet
- Align the toilet drain outlet with the vertical position of the drain outlet
- Installing toilet
Tips 1:
- The newly-renovated house is liable to damage the machine and affect human health due to residual debris such as mud and sand in the pipeline. Before installing, drain off the dirty water in the pipeline.
- Please choose a professional installer to install this product. After installation, please carefully check whether each part is installed correctly. After 48 hours, the glass glue is completely cured before use.
Tips 2:
After connecting the water pipe to open the angle valve, if there is water flowing from the nozzle in the new product, please plug it in and it will automatically reset the nozzle and stop the water. Be sure to turn off the power and water before disassembling.
- In the event of a power failure during the cleaning process, please do not move the spray boom After a call, the function returns to normal after a self-test.
- Be sure to use the special water inlet angle valve and other accessories provided by our company.
Caveat:
- Smart toilet accessories have been debugged before leaving the factory, and unauthorized disassembly is strictly prohibited. Please use the fittings and pipes provided by our company. Old fittings and pipes cannot be reused. If you have any questions, please contact your local dealer or our after-sales service department.
- All contents in this instruction manual are based on the latest situation of the product at the time of panting. Subject to change without notice.
CLEANING ANGLE VALVE
Turn off the angle valve switch, use a slotted screw diver or coin tool to unscrew the back cover switch, remove the filter and dean.
Customer Support
Thank you for choosing our smart toilet. Please read this manual carefully and
use correctly Please keep this manual properly and read it carefully before
use.
note: this instruction manual contains after-sales service guide.
Customer service: +86-19108027760 (Monday-Friday 9:00am-6:00pm)
Mail: service@witmya.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>