TECNO Camon 20 CK6NS Smartphone User Manual

June 14, 2024
TECNO Camon 20

TECNO logo

Camon 20 CK6NS Smartphone

TECNO CAMON 20
User Manual

Explosion diagram specification

TECNO Camon 20 CK6NS Smartphone - diagram
specification

1 FHD AMOLED 2 MAIN FRAME MYLAR
3 FRONT CAMERA FRAME 4 R CAM FRAME
5 FRONT ASSAY ASM 6 HOMEMADE PCBA MB
7 CAM FF 32M 8 REC PAD SBS GR
9 CAM AF 64M 10 R CAM PARCEL CON FOIL
11 FRONT CAM FILM 12 FP LMP FOAM
13 MAIN WATERPROOF FRAME 14 MC SCREW 25
15  SHIELD COP FOIL 16 MACHINE SCREW 35
17 NFC FILL FOAM 18 RAD FILM MI HOUSING
19 GB-COV ASM PREDAWN 20 CAM LENS RCAM 64M
21 CAM LENS RCAM 8W 22 SIM CARD HOLDER
23 SPEAKER HEAT FILM 24 BOX SPK
25 MID FRAME ASSAY 26 AUDIO JACK RUBBER
27 BAT BL 28 USB RUBBER
29 RUBBER LT SENSOR 30 USB FILM
31 RAD FILM MAIN 32 BAT MYLAR
33 COA CABLE 34 CAM FF 2M
35 FPCA SIDEKEY 36 CAM FF 8W
37 FPCA MAIN 38 RAD FILM LCM
39 HOMEMADE PCBA SUB 40 HEAT CON COPPER
41 REAR FLASH 42 ERM FPC
43 FP LINK FPC

Know your phone

TECNO Camon 20 CK6NS Smartphone - overview

  1. Front camera
  2. Volume + key
  3. Volume – key
  4. Power key
  5. NFC

SIM/SD card installation

  1. Power off mobile.
  2. Refer to the following picture for SIM / SD card installation.

TECNO Camon 20 CK6NS Smartphone - SD card

Charging the phone

You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty. TECNO Camon 20 CK6NS
Smartphone - Charging the phone

FCC Caution

Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Information to user.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: CK6ns(FCC ID:2ADYY-CK6NS) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.29W/kg and when properly worn on the body is 1.11W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

TECNO logoAndroid is a trademark of Google LLC.TM OS.
HiOS runs on Android

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals