YRU126 Pro Universal Cell Phone Holder Car User Manual
- June 14, 2024
- YRU
Table of Contents
YRU Car Phone Mount
User Manual
How to Get Product
Installation Video?
Scan the QR Code
https://www.amazon.com/stores/page/9A879511-242D-4630-BBDF-7C73B975C816
The suction cup is suitable for clean, flat, smooth, and non-porous surfaces.
Leather or textile dash surfaces are not suitable for installing all suction
cups, if you have these dashboards, please install the mount on the air vent.
To ensure the viscosity and absorption force of the the suction cup, please
clean the dashboard or windshield first before installing the suction cup
every time.
Using with the Suction Cup
-
Unscrew the nut and remove it.
-
Insert the ball joint into the back of the holder, and then screw the nut tightly.
-
Find a flat and smooth, clean once with a wet and dry towel each.
-
Turn on the “LOCK” button of the suction cup, and then tear off the plastic sealing film on the bottom.
-
Press the base for 5s, and then press the lock button. Wait for 20mins, and then ensure stability before usage.
-
Adjust the length and angle of the car mount as your like.
-
Tighten the knob to ensure stability. Leave it for 20mins to ensure the sucker is stable before use.
Another Suction Cup Installation
Rinsing the bottom of the suction cup then air-drying to restore its adhesion and reuse.
Pull up the lock button and remove the suction cup.
Using with the Air Vent Clip
The Suitability of Car Air Vent
| Horizontal and Vertical
| Non-intensive, Circular or Special-shaped
Note: To protect the air vent blade and air vent clip, don’t twist the air vent clip too tight.
-
Insert the ball joint into the back of the holder, and then screw the nut tightly.
-
Fix the clip onto the air vent grille, and then tighten vent clamp.
-
Turn clockwise to tighten the vent clamp.
Frequent Q & A:
How to avoid the mount falling off?
The correct installation procedure: Choose a flat and smooth surface. Clean the surface and wait for it to dry. Open the lock button. Tear off the plastic film on the suction cup. Press the base for 5s, and then press the lock button. Wait for 20mins, and ensure stability before usage. 2. It is recommended to use the vent clamp holder, below these situations: The surface texture of the dashboard has too deep lines or the slope is too big. The dashboard is leather surface, breathable surface, curved surface, plush cloth surface, uneven surface. The temperature outside the car is over 104℉/40 ℃,which cause the temperature inside the car to be over 203℉/95 ℃. High temperature, strong ultraviolet rays and dust will affect the suction and 3.stickiness, please avoid direct sunlight on the suction cup and clean it to restore vitality. 4.When the vehicle is regularly maintained, please check the stability of the mount, which depends on: The local road conditions, temperature, and the severity of ultraviolet rays. The depth of the texture and slope of the surface.
How to reuse the suction cup?
If the suction cup is loose, simply restore/ clean the sticky gel on your suction cup, rinsing the bottom of the suction cup then air-drying to restore its adhesion and reuse.
We will try our best to deserve your trust.
No need to return the items.
Replacement, 24-hour response, and 5 years warranty until your 100%
satisfaction if any problem:
Email: [email protected]
Website: http://yrulife.com
Email: [email protected]
Website: http://yrulife.com