SIAGO Electric Standing Desk Adjustable Instruction Manual
- June 14, 2024
- SIAGO
Table of Contents
- SIAGO Electric Standing Desk Adjustable
- Contact info
- Identify all the components
- Hardware identification
- INSTALLATION
- The interface of handset controller
- lnitialization Operation/ Reset
- Up Down Operation
- Store Position
- Select Height Setting
- Child Lock
- Error Code
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SIAGO Electric Standing Desk Adjustable
Contact info
Email: tangozalavip@qmail.com
Contact us or scan the QR code to activate your 2-YEAR warranty!
Defective? Missing parts?
we are here to help!
Email: tangozalavip@gmail.com
Identify all the components
Hardware identification
Note: Do not tighten screws until all screws have been started
INSTALLATION
The interface of handset controller
The key instructions:
- Up Key
- Down Key
- Save Key 1
- Save Key 2
- Save Key3
- Menu Setting
lnitialization Operation/ Reset
- The desk has been initialized before delivery and can be used directly.
- When the system is abnormal, or hand controller display the “-“, you need to make standing desk initialized. Initialization operation: Press the “DOWN” button, until the motor stopped then after 5 second, enter the initialization mode automatically.The Led display “RST” .At this time can’t loosen the “DOWN” button, if loosen “DOWN” button system initialization stop .When Initialization is complete, the buzzer will prompt, said initial success.
Up Down Operation
- Raise the Desk: Press the “UP” button, the desktop upward run, until reach the highest point of the desktop or the button is released.
- Lower the Desk: Press “DOWN” button, the desktop run down, until reach the lowest position or the button is released.
Store Position
The hand controller can store to 3 points, the storage method is as follows, when running to a specific point, press both of the “M” button and “1” or “2” or “3” button ,the LED flashes two times after 2 second , storage location to the corresponding label at this time.
Select Height Setting
Press the “1” or “2” or “3” button, and the desktop will move to the height that was previously set for that button.
Child Lock
Lock: Press and hold the “M” and “UP” buttons together for 5 seconds to tum child lock on. The screen will show ‘Loe’ and the buttons will be disabled. Unlock: Press and hold “M” and “Down” buttons together for 5 seconds to unlock.
Error Code
Error code | Instructions | How to do? |
---|---|---|
E-0 | Eeprom error | Change the controller |
E- 1 | Operational amplifier error | Change the |
controller
E-3| Over Current| Reduce the load
E-4| Main power voltage low| Check power
E-5| Motor Hall error| Check the hall or hall
line
E- 6| Motor over load| Reduce the load
E-8| Motor no connect| Check motor line
If you have any problems installing or using your standing desk,
do not hesitate to contact us.
Email: tangozalavip@gmail.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>