KING-WEAR BSW042 Smart Watch User Manual
- June 4, 2024
- KING-WEAR
Table of Contents
KING-WEAR BSW042 Smart Watch
Features
Power off:
This is a feature to turn off the watch.
App QR Code:
This is feature helps to download the app as it gives an OR Code on the watch
screen that is scannable.
Vibration:
This feature allows the user to turn on and off the vibration of the watch
Watch Status Reminder
incoming Call
When the watch receives incoming calls in no Bluetooth calling mode, it will
vibrate to remind you, also you can disconnect or reject the call.
Idle alerts
When you are sitting for a long time, the watch will vibrate to remind you to
get up for a while. Before using this function, you need to enable Idle alerts
by tapping “Profile” -> “Others”-> “Reminder To Move” and setting time for
Sedentary alerts and the do fit app.
Goal Notifications
When the number of steps reaches the set goal, the watch will vibrate to
remind you. Before using this function, you need to enable Goal notifications
by tapping “Profile” -> “Goal Setting” and set your goal on the Do Fit App
.
Watch Alarm Alert
When the alarm on the mobile phone rings, the watch will vibrate and brighten
to remind you that the alarm is ringing Before using this function, you need
to enable Watch alarm alert by tapping “Profile” -> “Alarm” and setting the
alarm fix time on the Da Fit App
Workout Function
Introduction to the Workout Function
Start Workouts
There are two approaches to starting o workout:
- Select o workout type in the Activity entry end to enable it;
- Press end and hold the touch button to quickly start the preset workout
The watch currently supports the following workout modes: Walking, Running,
Cycling, Skipping, Football, Basketball, Badminton.
FCC STATEMENT
FCC Caution:
This device complies with part 15 of the FCC. Rules. Operation is subject to
the following two conditions: (1)This device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to Company with the limiits for a
Class B digital device, pursuant to part i5 of the FCC Rules. These limiits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not Occur in a particular
installation. If this equipment does cause harmtul interference to radio or
television reception, which can be determined by turning the equipment oft and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reoriet. or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radiofTV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>