Gibson Exhaust 619719B Black Elite Single Swept Side Stainless Steel Exhaust Instruction Manual
- June 13, 2024
- Gibson Exhaust
Table of Contents
Gibson Exhaust 619719B Black Elite Single Swept Side Stainless Steel
Exhaust
Product Information
INSTALLATION INSTRUCTIONS
| Item | Description | Quantity |
|---|---|---|
| A | 2.5 Headpipe | 1 |
| B | Muffler Assembly | 1 |
| C | 2.5 Over axle pipe | 1 |
| D | 2.5 Exit pipe | 1 |
| E | 2.50 Band Clamp | 4 |
| F | 4.0 Black Ceramic Stainless Steel Exhaust Tip | 1 |
Thank you for purchasing our Gibson E xhaust system for your vehicle.
If you need further assistance, please do not hesitat e to call our technical
dept at 800-528-3044 Monday through
Friday, 8:00 am to 5:00 pm. 0222
-
Disconnect the negative battery cable before removal of the OEM Exhaust. This will allow the computer to reset and recognize the new exhaust. Lay out the exhaust on the floor so it looks like the drawing and compare parts with manual. Remove the factory exhaust by cutting 13” in front of factory muffler. Please refence photo below. Use wd-40 or another type of penetrating oil to remove the rubber grommets. Do not damage these they will be re used. Remove the rest fo the factory exhaust .
-
Please note the cut will be in the 2nd straight section in front of the factory muffler and is 13” from the front of the factory muffler forward.
-
Install Head pipe Item # A onto the factory pipe. Slide the muffler onto item # A. Be sure to mark all slip connections 3.0” to help determine the pipe position. Loosely tighten down.
-
Install the over axle pipe into the muffler. Loosely tighten down.
-
Install the exit pipe onto the over axle pipe and insert into rubber hangers. With exhaust loose make adjustments to find the proper tip position and clearance from all vehicle’s components.
-
With proper clearance from spare tire, install the exhaust tip onto the tailpipe. The system was designed to have the tip 1” below the bumper panel of the vehicle. With the tip in your desired position begin to tighten down all clamp connections from the front head pipe back.
-
Be sure to check all clearance after each section has been tightened to be sure there is proper clearance. It may take 4-500 miles for your vehicle to fully adjust to the changes in exhaust flow.
“MAKE SURE YOU HAVE A 1” CLEARANCE ON ALL PIPES FROM ALL RUBBER BRAKE LINES, SHOCK BOOTS, TIRES, ETC…” TORQUE ALL CLAMPS TO APPROX. 100 TO 150 FT LBS.
Documents / Resources
|
Gibson Exhaust 619719B Black Elite Single Swept Side Stainless Steel
Exhaust
[pdf] Instruction Manual
619719B Black Elite Single Swept Side Stainless Steel Exhaust, 619719B, Black
Elite Single Swept Side Stainless Steel Exhaust, Single Swept Side Stainless
Steel Exhaust, Swept Side Stainless Steel Exhaust, Side Stainless Steel
Exhaust, Stainless Steel Exhaust, Steel Exhaust, Exhaust
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>