GRWIBEOU XR24-02 Smart Home Transmitter LED Light Car Gate Garage Door Alarm Key Instruction Manual
- June 13, 2024
- GRWIBEOU
Table of Contents
2.4G Remote control instruction manual
Parameter:
Product model: XR24-02
Working voltage: DC3V (1pc CR2032 button battery)
Working current: Less than 20mA at launch
Working frequency: 2.402GHz-2.480GHz
Modulation method: GFSK
Standby curren: Less than 1μA
Size dimension: 553015mm
The quality of the product: 30g
Transmission power: 3dBm Maximum
Instructions for:
- Press the ON button, the indicator light is red, the signal is emitted, the machine is opened, loosen to stop the transmission.
- Press the OFF button, the indicator light is red, the signal is emitted, the machine is closed, loosen to stop the transmission.
- When the emission indicator is slightly on, the battery voltage is low, and a new battery needs to be replaced in time.
Application scenarios:
- Wireless mouse.
- Remote control toy.
- Intelligent furniture, etc.
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the device and receiver.
–Connect the device into an outlet on a circuit different from that to which
the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment