HUBBARDTON FORGE 201070 Triomphe Sconce Instruction Manual
- June 12, 2024
- HUBBARDTON FORGE
Table of Contents
ASSEMBLY & INSTALLATION INSTRUCTIONS
Triomphe Sconce 201070
B514
ASSEMBLY & INSTALLATION INSTRUCTIONS
Triomphe Sconce 201070
Component Parts
A. Fixture
B. Mounting Bracket
C. Ground Screw
D. Cupped Washer
E. #8 Screws (4)| F. Socket
G. Bulb (Not Included)
H. Glass
I. Cup
---|---
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS
PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE.
We recommend installation by a licensed electrician. This product must be
installed in accordance with applicable installation code(s), by a person
familiar with the construction and operation of the product and the hazards
involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only
recommended bulbs with fixture.
Please Note: After installation extra hardware and accessories are possible;
our kits are used on multiple products.
To Install Fixture (Figure 1) – on following page
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO
INSTALLATION.
-
Carefully unpack the fixture (A) from the carton.
-
Remove mounting bracket (B) from fixture (A).
-
Thread the wires in the electrical box through the hole in the mounting bracket (B) while moving the bracket into position. Place mounting bracket over electrical box and secure with two machine screws (not provided).
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use. -
Attach a pigtail lead to the mounting bracket (B) using the ground screw (C) and cupped washer (D) found in kit bag.
-
Hold fixture (A) close to wall. Using suitable wire connectors (not provided), connect fixture wires to supply wires (white to white and black to black). Connect all ground wires (bare copper or green to bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRE IS EXPOSED. -
Place fixture (A) over mounting bracket (B).Secure with #8 screws (E) on top and bottom of fixture. Be sure no wires are pinched between fixture and wall.
-
Install bulb (G) (not included) into socket (F).
-
Thread glass (H) onto socket (F) and inside cup (I)
-
Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please
contact the dealer from which you purchased this product. We hope you enjoy
your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by
improper installation, lamping or use of this fixture.
52570
Documents / Resources
|
HUBBARDTON FORGE 201070 Triomphe
Sconce
[pdf] Instruction Manual
201070, 52570, 201070 Triomphe Sconce, Triomphe Sconce, Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>