GUARDIAN ANGEL MCR-RF Wearable Safety Light Instruction Manual
- June 13, 2024
- GUARDIAN ANGEL
Table of Contents
Illumination Without Boundaries
MCR-RF Wearable Safety Light
Instruction Manual
MCR-RF Wearable Safety Light
Standard Remote (Sold Separate)
Operation: Beacon – White Work Light
Power ON or Power OFF Device for storage
Power ON
-
Option 1- Hold down Front and Rear buttons for 2 seconds
– Work light turns ON -
Option 2 -Plug your device in an AC Adapter using USB Cable
– Work light will single flash
– Double flash when charge is 100% -
Device turns ON at Max brightness
Power OFF
- Hold down the Front and Rear buttons for 3 seconds
– Work light flashes 3 times – unit is OFF.
Power Saver and Charging
Power Saver
After 2 hrs. if the remote has not been used the device will go into sleep
mode. To take devices out of sleep mode press any button on the device – this
wakes up the device.
Charging (0% – 100%- approx. 1.5 hours)
- Open sealed side door of the device and plug in Type-C USB cable.
Charging can be with any USB 1000mA AC adapter used with cell phones.
Note: Work light single flashes when charging Flashes twice when fully
charged.
Pairing – Group 1 & 2 – to a Standard Remote
Operation Range – 75 ft.
Pair – One or Multiple devices
Pro Tip: a Paired Device
Powered OFF and then Powered ON will remains PAIRED to remote
Step 1 – Power ON Device
Hold GA & Front button at the same time
When rotational pattern of LEDs turns ON, ready to Pair
Step 2
Hold GA Button to Pair remote to devices
Pairing is finished when 4 Corner LEDs blink 3 times
Pair – One or Multiple devices
Step 1 – Power ON Device
Hold GA & Rear button at the same time
- When rotational pattern of LEDs turns ON, ready to Pair
Step 2
Hold GA Button to Pair remote to devices Pairing is finished when 4 Corner
LEDs blink 3 times
Model #: MCR-RF
Pursuant to FCC 15.21 of the FCC rules, changes not expressly approved by
Archangel Device, LLC. might cause harmful interference and void the FCC
authorization to operate this product.
This product complies with the FCC RF radiation exposure limit set forth for
an uncontrolled environment.
This device complies with Part 15 of the FCC Rules and Innovation, Science and
Economic Development Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference. and (2) this
device must accept any interference received, including interference that may
cause undesired operation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>