Gosling Software v1.09 Can Slide Adjustment Settings User Guide
- June 13, 2024
- Gosling Software
Table of Contents
Gosling Software v1.09 Can Slide Adjustment Settings
Product Information
The Gosling Software v1.09+ is a software application designed to provide slide adjustment settings for the Can Slide feature.
Product Usage Instructions
- Open the Gosling Software v1.09+ on your computer.
- Navigate to the Can Slide Maintenance Page (refer to Figure 1).
- Locate the Can Slide Adjustment Settings section.
- Adjust the settings according to your preferences.
- Save the changes made to the Can Slide Adjustment Settings.
Gosling Software v1.09+ Can Slide Adjustment Setting
The purpose of this procedure is to educate the operator on the new settings
in software versions 1.09 and later to control can slide speeds. Note that the
settings in figure 1 are the default settings.
Navigate to the Can Slide Maintenance page by clicking on the Can Slide
button, once the page loads press the Can Slide button again to reveal the
pull-down menu and the Can Slide Maintenance button (see figure 1).
Settings and descriptions
DELAY TIMES (in seconds)
Can Gripper Ext/Ret Time:
This delay will control how much time the system will wait before the can
slide begins to move the can toward the seamer after the fill cycle is
complete.
If the delay is too short, the can slide will move before the can is fully gripped and may cause issues with loss of product/damaged cans.
Gosling Software v1.09+ Can Slide Adjustment Settings
STATION SPEED (percent):
All of the settings under the Station Speed title are set as percentages (out
of 100%) to control the speed of the can slide (and gripper) as it moves from
the fill head to the seamer and back.
Reference Figure 2 for to see the can slide zones.
To Fill Head:
This should be set at ‘100’ as it controls the speed at which the can gripper
moves back to the filler after the seaming cycle is complete.
To DO Hood:
This will control the speed of the can slide (gripper) as it moves the can
from the fill station to the end of the DO Hood (see figure 2).
Through Lid Dropper:
This will control the speed of the can slide (gripper) as it moves the can
from the end of the DO
Hood to the gap between the lid dropper and hockey skate (see figure 2).
To Seamer:
This will control the speed of the can slide (gripper) as it moves the lidded
can from the beginning of the hockey skate to the seamer station (see figure
2).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>