DUAL MWR30 (01) Wired Marine Remote Control Owner’s Manual
- June 13, 2024
- Dual
Table of Contents
MWR30
INSTALLATION/OWNER’S MANUAL
Wired Remote Control
MWR30 (01) Wired Marine Remote Control
MWR30
INSTALLATION
Preparation
Tools and supplies needed
You will need the following tools and supplies to complete the installation
process. It is best to have all of the following before beginning the
installation: Electric or cordless drill, 2 1/8″ hole saw (in-dash mounting
only), jigsaw, flat and Philips screwdrivers, pliers, file, wire cutters,
crimping tool, and electrical tape.
Before You Start
- Test remote terminal, with the head unit turned off, plug in the extension cable at both ends to the head unit and the remote control. Turn on the head unit and test the function of the remote control.
- Choose and prepare location, the MWR30 is designed to be mounted in a standard 2 1/8″ gauge cutout. The required mounting depth will vary, but at least 2 1/2″ is needed to mount the remote control. Surface mounting is also possible using the template on page 4.
NOTE: If a standard gauge cutout is not available and you use the
template provided on page 4 . Be sure to check behind the panel for wiring
harnesses, steering cables, hydraulic lines, fuel lines, gas tanks, etc. also
check to make sure you can get behind the dash panel, bulkhead, etc. to
attach the mounting bracket. Do not mount the unit where it can be submerged.
For Standard Gauge Cutout Mounting
- Attach plastic gasket to the back of remote housing and insert into gauge hole opening.
- Fasten to the aluminum mounting bracket with the included hardware.
For Surface Mounting
- Create three holes using template on page 4.
- Attach plastic gasket to the back of remote housing and place insert into holes created.
- Fasten to the aluminum mounting bracket with the included hardware.
Standard Gauge Cutout Mounting
Surface Mounting
Surface Mounting Template
Wiring
Once the remote has been mounted, connect the cables to the remote and head unit as in the diagram above. When routing the extension cable, be sure to avoid sharp objects, corners, and places where it might get pinched, as this could affect performance and cause damage to the unit.
Control Locations
General Operation
Power On/Off| Press POWER or any other button (except VOLUME )
to turn the remote and head unit on. Press POWER to turn the unit off.
---|---
Mode| Press MODE to select one of the following modes: Tuner, Weather band,
CD, Auxiliary. The remote will only display the modes available on the radio
being
controlled.
Volume| Press VOLUME adjust volume up/down.
Programmable Turn-On Volume| Press and hold POWER button for 3 seconds to
program currently selected volume level. “P-VOL” and the current volume level
will momentarily appear in the head unit’s display.
Mute| Press MUTE to silence the audio. “MUTE” will flash in the head unit’s
display. Press MUTE again to cancel.
Band| Press BAND to select between FM1, FM2, FM3, AM1, and AM 2 bands in tuner
mode.
Play/Pause| Press to temporarily stop playback in CD mode.
Press again to resume playback in CD mode.
Seek Tune| Press TUNE or TUNE momentarily to seek the next strong
station in tuner mode.
Manual Tune| Press TUNE or TUNE for more than 2 seconds, then
release. “MANUAL” will momentarily appear in the display. Press TUNE or
TUNE momentarily to move radio frequency up or down one step at a time.
Press and hold to advance quickly. If
tuning is not adjusted for 5 seconds, the head unit will return to seek tuning
mode (default). “AUTO” will momentarily appear in the head unit’s display.
Track Select| Press TRACK to skip to the beginning of the next track in
CD mode. Press TRACK to return to the beginning of the current track.
Pressing TRACK again skips to the beginning of the previous track.
WB Preset Select| Press TUNE or TUNE in weather band mode to move
weather band frequency up or down one preset at a time.
NOTE: Reference the head unit owner’s manual for additional operation
instructions specific to that head unit.
Limited One Year Warranty
This warranty gives you specific legal rights.
You may also have other rights which vary from state to state.
Dual Electronics Corp. warrants this product to the original purchaser to be
free from defects in material and workmanship for a period of one year from
the date of the original purchase. Dual Electronics Corp. agrees, at our
option, during the warranty period, to repair any defect in material or
workmanship or to furnish an equal new, renewed or comparable product
(whichever is deemed necessary) in exchange without charges, subject to
verification of the defect or malfunction and proof of the date of purchase.
Subsequent replacement products are warranted for the balance of the original
warranty period.
Who is covered? This warranty is extended to the original retail
purchaser for products purchased and used in the U.S.A.
What is covered? This warranty covers all defects in material and
workmanship in this product. The following are not covered:
installation/removal costs, damage resulting from accident, misuse, abuse,
neglect, product modification, improper installation, incorrect line voltage,
unauthorized repair or failure to follow instructions supplied with the
product, or damage occurring during return shipment of the product.
What to do?
- Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls or connections discussed in your instruction booklet may save you a service call.
- If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center.
- Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment.
- For more information and for the location of the nearest authorized service center please contact us by one of the following methods: Call us toll-free at 1-866-382-5476 E-mail us at cs@dualav.com
Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.
www.dualav.com
©2006 Dual Electronics Corp. All rights reserved.
NSA0106-V01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>