AprilAire Z10IDT Wireless Indoor Temperature and Humidity Sensor Instruction Manual
- June 13, 2024
- Aprilaire
Table of Contents
Sensor
INSTALLATION AND
**OPERATOR’S MANUAL
Model Z10IDT
Wireless Indoor Temperature
and Humidity Sensor
**
READ AND SAVE THESE INSTRUCTIONS
DIMENSIONS
SPECIFICATIONS
| Communications | 2.4 MHz |
|---|---|
| Wireless range | 35 feet |
| Temperature measurement range/accuracy | Accuracy: ±2°F (40°F to 105°F), ±5°F |
outside of this range
Range: -40°F to 125°F
Humidity measurement range/accuracy| Accuracy: ±5% RH between 20% and 80% RH
Range: 0.5% to 99.5% RH
Battery life| Approximately 1 year
Battery type| Lithium CR2032 type
FEATURES
WHEN USED WITH APRILAIRE MODEL S86WMUPR THERMOSTAT:
- Sensor controlled scheduling – heat/cool calls can be controlled by averaging inputs from all sensors, or control a scheduled event with a specific individual sensor input.
- Pair up to 8 indoor temperature sensors with your AprilAire thermostat.
BATTERY REPLACEMENT
- Slide the backing plate down to remove from sensor.
- Remove battery.
- Replace battery with lithium CR2032 type.
- Replace backing plate on sensor.
MOUNTING THE WIRELESS INDOOR SENSOR
NOTE : Pair sensor with Wi-Fi thermostat before mounting.
The sensor should be mounted:
- On an interior wall, in a frequently occupied space.
- Within 35 feet of thermostat.
- Approximately 5 feet above the floor.
- At least 18” from the outside wall.
Do not mount the sensor:
- Behind doors, in corners or other dead air spaces.
- In direct sunlight, near lighting fixtures, or other appliances that give off heat.
- On an outside or unconditioned area wall.
- In the flow of a supply register, in stairwells, or near outside doors.
- On a wall with concealed pipes or ductwork.
PAIRING THE SENSOR TO THE S86WMUPR THERMOSTAT
-
On the thermostat, navigate to wireless sensor settings:
Menu > Settings > Installer Settings (press and hold UP and DOWN 5 seconds) > Wireless Sensors > Add. -
On the sensor, press and hold the pairing button 5 seconds (the red indicator on the front of the sensor will start flashing).
-
On the thermostat, select Continue and wait for the pairing process to complete.
LOW BATTERY DISPLAY
When the battery gets below 30% life left the sensor will flash the LED once every 10 seconds. The connected/ paired device will display sensor low battery screen (see your thermostat or connected device manual).
SENSOR LED AND BUTTON FUNCTIONALITY
LED STATUS
Flashes once per second| Connectivity status (pairing mode). NOTE: The sensor
exits pairing mode after 30 seconds.
Flashes once per 10 seconds| Battery low power status.
BUTTON FUNCTION
Press and hold 5 seconds| Enter pairing mode.
TROUBLESHOOTING
If the wireless sensor is experiencing connection issues with the thermostat, verify the following:
- Connect the thermostat to a Wi-Fi network to verify the latest firmware is installed. The latest firmware will automatically install once connected to Wi-Fi.
- On the sensor, press and release the pairing button once. This will send updated information to the thermostat.
- On the thermostat, navigate to wireless settings: Menu > Settings > Installer Settings (press and hold UP and DOWN 5 seconds) > Wireless Sensors > View.
- Note the RSSI value located within the View Sensor screen. The RSSI value should be greater than -70 dBm (see illustration below).
a. If the RSSI value is less than -70 dBm, relocate the sensor and repeat steps 2-4.
b. If the RSSI is greater than -70 dBm and connection issues persist, contact AprilAire customer support at 800.334.6011.
IC WARNING
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device
FIVE YEAR LIMITED WARRANTY
Your AprilAire® Wireless Indoor Temperature and Humidity Sensor is expressly
warranted for five (5) years from date of installation to be free from defects
in materials or workmanship.
AprilAire’s exclusive obligation under this warranty shall be to supply,
without charge, a replacement for any sensor which is found to be defective
within such five (5) year period and which is returned, together with the date
of installation, no later than thirty (30) days after said five (5) year
period by you to either your original supplier or to AprilAire, Madison,
Wisconsin 53701.
THIS WARRANTY SHALL NOT OBLIGATE APRILAIRE FOR ANY LABOR COSTS AND SHALL NOT
APPLY TO DEFECTS IN WORKMANSHIP OR MATERIALS FURNISHED BY YOUR INSTALLER AS
CONTRASTED TO DEFECTS IN THE SENSOR ITSELF.
IMPLIED WARRANTIES OF MERCHANTABILITY OF FITNESS FOR A PARTICULAR PURPOSE
SHALL BE LIMITED IN DURATION TO THE AFORESAID FIVE YEAR PERIOD. APRILAIRE’S
LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL AMAGES, OTHER THAN DAMAGES FOR
PERSONAL INJURIES, RESULTING FROM ANY BREACH OF THE AFORESAID IMPLIED
WARRANTIES OR THE ABOVE LIMITED WARRANTY IS EXPRESSLY EXCLUDED. THIS LIMITED
WARRANTY IS VOID IF DEFECT(S) RESULT FROM FAILURE TO HAVE THIS SENSOR
INSTALLED BY A QUALIFIED HEATING AND AIR CONDITIONING CONTRACTOR. IF THE
LIMITED WARRANTY IS VOID DUE TO FAILURE TO USE A QUALIFIED CONTRACTOR, ALL
DISCLAIMERS OF IMPLIED WARRANTIES SHALL BE EFFECTIVE UPON INSTALLATION.
Some states do not allow limitations on how long an implied warranty lasts or
the exclusion or limitation of incidental or consequential damages, so the
above exclusions or limitations may not apply to you.
This warranty gives you specific legal rights and you may also have other
rights which vary from state to state.
This equipment if installed in strict accordance with the manufacturer’s
instructions, complies with the limits for a Class B computing device pursuant
to Subpart J of Part 15 of FCC Rules.
WARRANTY REGISTRATION
Visit us on-line at aprilaire.com to register your AprilAire product. If you
donot have on-line access, please mail a postcard with your name,
address,phone number, product purchased and date of purchase to: AprilAire,
P.O.BOX 1467, Madison, WI 53701
Your warranty registration information will not be sold or shared outsideof
this company.
FCC AND ISED COMPLIANCE STATEMENTS
Contains FCC ID: 2AUXB-DSBC070
Contains IC: 25658-DSB070
This device complies with Part 15 of the FCC Rules and with Innovation,
Science and Economic Development Canada’s License-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Interference Statement – Part 15.105 (b)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC and Innovation, Science and Economic Development Canada’s RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be operating in conjunction with any other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures.
B2209932B • 61002193 • 02.23
© 2023 AprilAire | aprilairepartners.com | 800.334.6011
AprilAire reserves the right to change specifications without notice.
Documents / Resources
|
AprilAire Z10IDT Wireless Indoor Temperature and Humidity
Sensor
[pdf] Instruction Manual
Z10IDT Wireless Indoor Temperature and Humidity Sensor, Z10IDT, Wireless
Indoor Temperature and Humidity Sensor, Indoor Temperature and Humidity
Sensor, Temperature and Humidity Sensor, Humidity Sensor, Sensor
---|---