B-AIR KP-680 Inflatable Blower Instruction Manual
- June 13, 2024
- B-AiR
Table of Contents
Koala KP-680
Instruction Manual
THANK YOU FOR PURCHASING A B-AIR PRODUCT.
Introduction to Koala KP-680
Your new B-Air Koala #KP-680 blower is highly efficient. Easy to transport and carry with its built-in handles, the Koala #KP-680’s were constructed to be lightweight and unobtrusive.
Operation/Use
This high air volume unit is intended to inflate inflatable play and game structures, but is also suitable for a variety of other applications.
- Carefully place the B-Air unit on a stable, flat and dry surface.
- Attach an inflatable tube around the exhaust opening using straps or any other form of tightener.
- Plug the power cord into a grounded GFCI outlet.
- Turn on the switch and make sure it is operating correctly.
- All blowers in operation must be supervised at all times.
Storage
Store unit indoors in a clean and dry environment to ensure product integrity and long life.
Warning
All blowers in operation must be supervised and attended at all times.
The use of a 3-prong to 2-prong adapter is prohibited.
If the power supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid safety
hazards.
Safety
-
Blower must have back pressure, meaning it must be attached to an inflatable or duct to avoid any damage to the motor.
-
Keep children away from unit at all times while in operation and/or plugged in.
-
Do not put fingers or other objects in unit while in operation and/or plugged in.
-
Do not operate in pooled water to avoid electric shock.
-
Unit must be kept dry at all times, including motor, wiring and exterior. If unit becomes wet, thoroughly dry before next operation.
-
Indoor use: Use only with a grounded plug and/or extension cord to avoid risk of electrical shock or fire. Remember never to use a power cord with any kind of damage or wear.
-
Make sure the power source is sufficient to meet the requirements of the blower.
-
Keep air intakes clear at all times to avoid clogging or blocking in order to prevent the unit from overheating. Blocking the air intakes could result in a fire or electrical hazards.
-
Do not remove any screens or safety guards from the unit to prevent injury to persons and to avoid objects from coming in contact with the blower wheel.
Unit damage in this manner will void your warranty. -
Do not operate unit close to any dangerous areas, such as explosive gases, flammabies, heaters and unventilated environments; this may result in explosions or electrical hazards.
-
Do not use any form of speed control devices. Doing so may risk injury or fire.
-
Always place blower on a smooth and leveled surface for safe operation.
-
Do not operate in stacked position.
-
Do not use unit if damaged.
-
Before cleaning or servicing, unplug unit.
-
All blowers in operation must be supervised at all times.
-
Do not expose to rain, water or snow.
-
Outdoor use: unit must be connected to a G.F.C.1 (ground fault circuit interrupter) protected receptacle.
Limited Warranty
Proof of purchase is required on all warranty claims.
Warranty covers against defects in material and craftsmanship used under
normal intended use to original purchaser for a term of (6) months from the
original date of purchase including parts, labor and 1 way shipping.
Important!
arranty does not cover signs of misuse including, but not limited to rough
handling, abuse, tampering, improper voltage use and unauthorized maintenance
and repairs.
Service
In order to receive service or replacement parts under warranty, you must:
A. Call for an RMA (Return Merchandise Authorization Number)
B. Have proof of purchase
C. Ship to B-Air
Upon inspection, we will advise you of the repairs needed and the cost (if applicable). B-Air will issue repair or replacement parts depending on warranty.
Cords
- Do not use extension cords for outside use.
- Use 3 prong adaptors that are UL and CE approved and not less than 14-3 with ground fault circuit interrupter (GFCI).
- Do not use cords that show any kind or wear or damage.
- Cords are not covered by warranty.
Troubleshooting
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| Motor Not Running | a)Switch is OFF |
b)Bad Outlet
c)Faulty Switch/Cord| a)Turn Switch ON
b)Check Outlet/ Change to
Another Outlet
c)Call Factory for new
Switch/Replace Cord
Scraping Noise From Blower| a) Wheel Out Of Line| a) Call Factory for
Replacement Advise
Weak Air Flow| a) Obstructed Vents/Inlets| a) Clean Out Vents/Inlets
Specifications
| VOLTS | 115 V | 230 V |
|---|---|---|
| MAX AIR VOLUME | 447 CFM | 569 CFM |
| AMPS | 4.5 A | 2.3 A |
| MAX STATIC PRESSURE | 6.25 INCH | 7.5 INCH |
| WEIGHT NET/SHIP | 13/I6LBS | 18/22LBS |
| UNIT SIZE (L x W x H) | 16.2″x 16.2″ x 11.5″ | 17A”x 17.4″ x 12.6″ |
| MOTOR | 1/2 HP | 1/2 HP |
| MOTOR POWER | 680W | 680W |
| ATTACHED CORD | 6 FT | 6FT |
PART LIST
Explosion of kodiak kp -680
WARRANTY REGISTRATION
Please complete and mail or fax your product warranty registration card For
multiple units. please list serial numbers on a separate sheet.
THIS WARRANTY CARD AND YOUR BILL OF SALE MUST BE PRESENTED FOR WARRANTY
SERVICE.
Your Company Name————-
Contact Name —————–Title——–
Address ———-
City —————State ————-Zip————–
Phone———————–Fax———-
E-mail——————
Koala KP-680
Serial Number ——————Date of Purchase —————-/ ————–/
Purchased From————–
Additional Comments/Suggestions—————
550 South Ayon Ave. Azusa. CA 91702
1-877-800-2247 (BAIR)
Fax: 626-385-3307
Email: [email protected]
Web site: www.b-air.com