Zhongshan Hanfan Electronic Technology 9107 Fan Light Remote Controller Instructions
- June 13, 2024
- Zhongshan Hanfan Electronic Technology
Table of Contents
9107 Fan Light Remote Controller
As shown in the figure:
- button: Press this key to turn on or off the fan。
- 1 -6Number button: Gear 1-6 is the fan/motor speed button, gear 1 is the lowest speed, gear 6 is the highest speed。
- button: This key can turn off the indicator light and electric fan。
- button: Press this key to turn on or off thelight
- Natural wind button: Press this key for natural wind, and the fan rotates from the current gear to the first gear。
- button: This key can control the fan to rotate counterclockwise。
- button: This key can control the clockwise rotation of the fan。
- 1H、2H、4H:Is the timed shutdown key, press this key, 1H/2H/4H later turn off the motor。
Restore electrical power.Within 30 seconds of restoring electrical power, press and hold the “ ”button on the remote controtransmitterfor 5seconds or until ight on the fan。
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
The devices has been evaluated to meet general RF exposure requirement, the
device can be used in portable exposure condition without restriction