Guangdong Xintengda Communication Technology WR300N-XXX WiFi Router Instruction Manual
- June 13, 2024
- Guangdong Xintengda Communication Technology
Table of Contents
Xintengda Communication Technology WR300N-XXX WiFi Router
Instruction Manual
WR300N-XXX WiFi Router
Step 1
The device is powered on, and the WAN port of the router is directly connected to the optical modem or cell broadband with the network cable
Step 2 Note: If this method is not available online, you can turn the back of this tutorial, there are specific steps to teach you to set up, or you can also consult customer service.
How the router is not available for internet access
Method 1: Change the dynamic IP to PPPOE dialing
Step 1: Power on the device and plug in the network cable Connect the
phone to the router Wi-Fi (starting with WR300H) and turn off the mobile data
Step 2: Open a browser, enter 192.168.18.1 to enter the background, and
enter the administrator password: admim (see Figure 1.1)
Step 3: Click Dynamic IP to modify to PPPOE after entering, and then you
need to enter your broadband account and password, remember to click Save.
(See Figures 1.2 and 1.3)
Warranty card
This warranty card is a product warranty certificate, please be sure to fill in detail and properly protect the official
User name|
---|---
Coot|
Mailing address|
E-mail|
Product model|
Product|
Production enterprises|
Production address|
Salle|
Seller address|
Seller|
Phone|
Date of purchase|
Dear users, please ask the seller to fill in the above information letter when
purchasing, and cooperate with it, thank you
How to restore the router factory settings?
Hold down the “RESET” button on the back of the router for about 10 seconds
while the power is on. The configuration parameters of the router will be
cleared after the factory setup is restored, and the router needs to be reset
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Router setup tutorial
Thank you for using this product
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>