i-PRO WV-QDC100C-W Dome Cover Instruction Manual

i-PRO WV-QDC100C-W Dome Cover

• Before attempting to connect or install this product, please read these instructions carefully and save this manual for future use.
• The external appearance and other parts shown in this manual may differ from the actual product within the scope that will not interfere with normal use due to improvement of the product.

i-PRO Co., Ltd. assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation.

• “<Control No.: C****>” used in these documents should be used to search for information on our technical information website (https://i-pro.com/global/en/surveillance/trainingsupport/support/technical-information) and will guide you to the right information.

i-PRO Co., Ltd.

• https://www.i-pro.com/
• © i-PRO Co., Ltd. 2022

Installation

Step 1

• Connect the cables to the camera, and fix them to the ceiling. (Refer to the Installation Guide of the camera in use.)

Step 2

• Remove the lower part of the decorative cover, and attach this product to the upper part of the decorative cover.

• The decorative cover (Lower) is not used.
• The decorative cover (Lower) is secured with hooks at 3 places.
• This product is also secured with the same hooks.

About notations

• Some functions are expressed with the following notations in this document.
• Clear dome cover
• Smoke dome cover

Preface

• This product is a dome cover that is designed to mount the indoor PTZ type camera.
• The latest information about the supported cameras

Specifications

• Ambient operating temperature: –10 °C to +55 °C {14 °F to 131 °F}
• Dimensions: ø156 mm x 162 mm (H) {ø6-5/32 inches x 6-3/8 inches (H)}, diameter of the dome: 73 mm {2-7/8 inches}
• Mass: Approx. 200 g {0.44 lbs}
• Finish: Main body: ABS resin i-PRO white Dome cover: Acrylic resin (Transmittance: approx. 50 %)

Standard Accessories

• Operating Instructions (this document)…….. 1 pc.

Caution

• Before attempting to connect or operate this product, please read these instructions carefully.

Precautions

• Do not use this product except with suitable cameras.
• Failure to observe this may cause a drop resulting in injury or accidents.
• Refer installation work to the dealer.
• Installation work requires technique and experience. Failure to observe this may cause fire, electric shock, injury, or damage to the product.
• Be sure to consult the dealer.
• When using this product, also read the “Precautions” described in the operating instructions for the camera to be attached.

Step 3

• Remove the protective sheet from the lens surface of the camera.

Step 4

• Align the “|” mark of the decorative cover (Upper) and the arrow mark of the camera body, and insert this product from the bottom.
• After inserting the decorative cover, rotate it clockwise when looking at it from underneath by 2 steps to engage the cover by pushing it up as shown in the drawing below.
• Make sure that the lock lever is securely inserted into the slot of this product. Then remove the protective sheet from the dome cover of this product.

Note

• To remove the decorative cover from the camera body, rotate the decorative cover counterclockwise when looking at it from underneath and pull it slightly downward while pressing the lock lever.
• The body part of this product may be caught in the view depending on the lens direction and the angle. In such a case, adjust the lens direction.

https://www.i-pro.com/.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>