Xemex P1MB P1 Modbus Converter User Guide

June 13, 2024
xemex

CONFIGURATION MANUAL
P1MB
P1 Modbus converter

Copyright © XEMEX
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without prior written permission of the publisher.

Interfaces – data ports

  1. P1 input Customer data port connection
  2.  Optional 5V power supply input
  3. Modbus output
  4. Led indicators

Configuration

Step 1: Connect the device to your PC
Connect the device to your PC with the cable that matches the communication port of the device (1) and your PC. Make sure the connection is secure. Kindly note that the cable is not included in the price and must be purchased separately.

Step 2: Open the Xemex P1MB configurator on your PC.
Open the Xemex P1MB configuration application on your PC. If the input fields are gray and therefore not editable, go to step 3. If the input fields are white and therefore editable, continue to step 5.

Step 3: Identify the port number
The USB serial port adapter you connected is assigned a serial port number by your PC. Go to Device  Manager on your PC to identify this serial port number. You can access the Device Manager through ControlPanel or through My Computer, then select Properties to go to Device Manager.
Step 4: Configure the communication settings of the device with those of your PC
Click Read current P1MB configuration. In the pop-up window Read current P1MB configuration via P1, at P1 COM port, read the communication port that the device communicates with. It should be the same as the port number identified in step 3 in Device Manager. If not, change the communication port in this popup window. Click OK to save your changes.

Step 5: Enter the desired parameters
You can now enter the desired parameters in the fields. Do not change the parameters P1 baud rate and P1 line settings. Changing these parameters will prevent the operation of the P1MB.

Modbus baud rate
Enter the desired baud rate (range: 1200 … 115200). All devices connected to the bus must use the same baud rate. The protocol does not specify a specific baud rate. The default value is 9600 baud. Modbus line settings
Options:
8N1 = 8 data bits, no parity, 1 stop bit
8E1 = 8 data bits, even parity, 1 stop bit (default)
Modbus device address
Configure the modbus address in this input box. The range is 1 to 247. The default value is 16.
Modbus termination
The P1MB is equipped with a line terminator resistor. The Modbus termination is not activated by default.
Step 6: Click Update P1MB configuration to save your changes.

21 June 2023
XEMEX Confidential

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals