Jabra PanaCast 50 Video Bar System Screen Mount User Manual
- June 13, 2024
- Jabra
Table of Contents
PanaCast 50 Video Bar System
Screen Mount
PanaCast 50 Video Bar System Screen Mount
Install below screen
Start from page 1 Install above screen
Start from page 9
Screen Mount horizontal section
Screen Mount vertical section
Tools needed (not supplied in the pack)
If the screen is already wall-mounted, remove it from the wall.
- Detach the existing VESA mount from your screen.
Measure the distance between the VESA mount hole and the bottom of the screen. This distance is X.
Assemble the Screen Mount and ensure that the distance illustrated is approx X +10 cm or X +4 inches.
Screw the horizontal and vertical sections together using the supplied M5x8 screws and a 4 mm hex key.
Stick the adhesive protective pads to the back of the Screen Mount.
Screw the wall Mount to the Screen Mount using the M5x12 screws and a 4mm hex key.
- Select the screws, washers and spacers that best fit the contours of your screen.
Screw the Screen Mount and the VESA mount (not supplied) to the screen as illustrated, using the ideal spacer length for the uppermost screws.
Attach the video bar to the Screen Mount. Screws are not required.
Rotate the video bar down for easy access to the ports.
Attach the relevant cables to video bar..
Screw the cable cover to the video bar using the supplied screws.
Rotate the PanaCast 50 into its final position and angle the camera to point at eye-level.
- If the screen is already wall-mounted, remove it from the wall.
- Detach the existing VESA mount from your screen.
- Measure the distance between the VESA mount hole and the top of the screen. This distance is X.
- Assemble the Screen Mount and ensure that the distance illustrated is approx X +10 cm or X +4 inches.
- Screw the horizontal and vertical sections together using the supplied M5x8 screws and a 4 mm hex key.
- Stick the adhesive protective pads to the back of the Screen Mount.
- Screw the wall Mount to the Screen Mount using the M5x12 screws and a 4mm hex key.
- Select the screws, washers and spacers that best fit the contours of your screen.
- Screw the Screen Mount and the VESA mount (not supplied) to the screen as illustrated, using the ideal spacer length for the uppermost screws.
- Attach the video bar to the Screen Mount. Screws are not required.
- Rotate the video bar down for easy access to the ports.
- Attach the relevant cables to video bar.
- Screw the cable cover to the video bar using the supplied screws.
- Rotate the PanaCast 50 into its final position and angle the camera to point at eye-level.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>