ring Smart Lighting Solar Floodlight User Guide
- June 13, 2024
- Ring
Table of Contents
ring Smart Lighting Solar Floodlight User Guide
Download the Ring app
The Ring app walks you through setting up and managing your Floodlight.
Search for “Ring” in one of these app
stores, or visit: ring.com/app.
Set up your Ring Bridge
The Bridge is required to connect your Ring Smart Lights to the Ring app and other compatible Ring devices.
To set up your Bridge, follow the instructions in the Ring app or theBridge
user manual.
Remove the back cover.
Twist your Floodlight counter-clockwise to unlock and separate it from the
back cover
Remove the battery.
Push the metal tab and remove the included battery from the battery
compartment.
Remove the battery strips.
Carefully remove and discard them
Charge the battery.
Fully charge the battery by plugging it into a power source using the provided
orange cable. Once only one light is lit, it’s fully charged.
= Charging
= Charged
Insert the battery.
Insert the included battery and push until it snaps in place.If you like,
you can purchase and insert a 2nd battery to make your Floodlight last longer
when bright sunlight is rare.
Set up your Floodlight in the Ring app.
In the app, tap Set Up a Device.When prompted, select Smart Lightingand follow
the in-app instructions.After setup, replace the back cover (be sure to line
up the arrows).
Remove the mounting plate.
Press the tab on the side and slide the mounting plate off of the back cover.
Mark pilot holes.
Mark your holes using the mounting plate as aguide, making sure the“UP” arrow
is pointing upwards
Drive the screws.
Hold the mounting plate firmly against the surface and drive the three
mounting screws.
Mount your Floodlight.
Align your Floodlight with the mountingplate and slide it to the left to lock
it in. Next, let’s set up your Ring Solar Panel.
The motion sensor is adjustable. Try various angles to find the best setting
for your home.
Mark pilot holes.
Select an install location within 13 feet of your Floodlight, where the Solar
Panel can get direct sunlight.
Mark the holes usingthe mounting arm as atemplate, and refer topage 12 to
install wall anchors (if needed).
Screw in the
Mounting Arm. Drive the included mounting screws into your wall (or the wall
anchors, if installing on a hard surface)until the mounting arm is secure.
Attach the Solar Panel.
Position the slots in the rear of your Solar Panel over the mounting arm
and slide it down to secure it.
Adjust the Angle.
Loosen the screw on the mounting arm and adjust the panel to your desired
angle, then re-tighten the screw to secure your setting.
You can rotate and tilt your Solar Panel to get the best orientation for your
home.
Connect the cable.
Once your Solar Panel is mounted,insert the power plug into thepower input
at the bottom of your Floodlight.
For additional help, visit : ring.com/help
Or give us a call…
US 1 800 656 1918
Canada 1 855 300 7289
Worldwide +1 310 929 7085
For a list of all our customer support numbers,
visit: ring.com/callus
2019 Ring LLC or its affiliates.
Ring and all related logos are trademarks of Ring LLC or its affiliates
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>