Azzardo Dazzling LED Suspended Light Instructions

Azzardo Dazzling LED Suspended Light

Product Information

• The product is a ceiling light fixture with multiple rings.
• Each round ring has two braided suspension wires and a clear 2-core flex.
• The product comes with an LED driver for electrical connection.
• The ceiling rose is included in the packaging.
• The rings are covered with a plastic film that needs to be removed before use.

Product Usage Instructions

1. Open the box and lift the ceiling rose around 20cm without raising the rings.
2. Turn the ceiling rose over so that the bundled cables hang correctly. If there is a twist, repeat until the cables hang without a twist.
3. Lift the box and contents to the ceiling and make the electrical connection to the LED driver.
4. Fix the fixture to the ceiling. Optionally, temporarily hang the enclosure with cable ties to make adjusting wire length easier.
5. Lower the packaging, and the rings will hang without a twist.
6. If there is a tangle in the suspension wires, undo the hex grub screw where they join the rings and remove the two suspension wires without touching the clear electrical flex. This allows you to remove twists and disentangle the fixture.
7. To adjust the height of each ring, change the length of both suspensions and the electrical flex. Snipping the bottom of the wire suspensions and clamping the cut end at the rings is suggested. Push up the clear electrical wire into the ceiling assembly and release (lower) the suspensions by pushing the clutch in.
8. If you need to stuff lots of suspension wire and clear flex back into the ceiling rose, consider either lowering the ceiling rose or using the method suggested in point 8.
9. Excess braided suspension cables can be cut, but avoid cutting the 2-core wire unless you are willing to rewire the LED driver.
10. If individual rings keep rotating from where you want them to hang, release any twists from each suspension wire.
11. Once you are satisfied with the arrangement, remove the plastic film from the rings.

INSTALLATION

1. Don’t try this on your own – two or more are required to install this light fixture. Wear gloves. Do not cut plastic cable ties on opening – read the instructions.

2. Open the box and lift the ceiling rose around 20cm. Do not raise the rings.

3. Turn the ceiling rose over so the bundled cables hang correctly. If there is an obvious twist, go back and turn again until the ceiling rose has bundled cable hanging without a twist.

4. Lift the box and contents to the ceiling. Make the electrical connection to the driver.

5. Fix to the ceiling. Note: Temporarily hanging the enclosure with some cable ties may make adjusting wire length easier – your choice.

6. Lower the packaging and the rings will hang without twist.

7. Each round ring has two braided suspension wires and a clear 2-core flex.

   • If you have a tangle – undo the hex grub screw where the suspension wires join the rings and remove the two suspension wires. Do not touch the clear electrical flex. This will allow you to remove twists in the suspensions and disentangle the fixture.

8. You can adjust the height of each ring by changing the length of both suspensions and the electrical flex.
   Suggestion: Many find it easier to snip the bottom of the wire suspensions and clamp the cut end at the rings. The clear electrical wire must be pushed up into the ceiling assembly. Push the clutch in to release (lower) the suspensions.

9. If you are stuffing lots of suspension wire and clear flex back into the ceiling rose consider either lowering the ceiling rose to make this easier. Or use the suggestion in point 8.

10. Excess braided suspension cables can be cut. Do not be tempted to cut the 2-core wire unless you are happy to rewire the LED driver.

11. If individual rings keep rotating from where you feel they should hang, the individual suspensions are twisted on that ring. Release twists from each suspension (see 7 above)

12. Once you are happy with the arrangement remove the plastic film from the rings.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>