Lunasea LL64 LunaSafe Pool Boat Wearable Transmitter Owner’s Manual
- June 12, 2024
- LUNASEA
Table of Contents
**Lunasea LL64 LunaSafe Pool Boat Wearable Transmitter
**
Transmitter
Transmitter Functions
Transmitter is a wearable device that has a approx 5 year battery built in. When tranmitter comes in contact with water it will send a signal to the receiver alarm which will sound audible and visual alarm.
Locking Wrist Strap
After threading the nylon strap through safety device and back through the
locking connector, turn locking button 90 degrees as shown using a coin or
screwdriver.
Receiver/Alarm
Charging Receiver
Make sure the unit is fully charged by placing it standing up on a charge pad. Then wait until Charging Light goes off.
Turn Receiver On
Momentarily press On/Off Button to turn on. Unit initializes and then Ready indicator blinks showing unit is in normal operation.
Low Battery
When battery becomes low the Low Bat Indicator will Blink.
Place unit on Charge Pad until battery is fully charged.
Charging light will then go off indicating full charge.
Pairing Receiver with Transmitter
Press and hold the Check Button for 5 seconds then with wet fingers, wet cloth
or dipped in water across both gold pins.
You will see Pairing indicator blink multiple times showing the the device has
been paired. You can do this with up to 25 tranmitters.
To delete all pairing information, press and hold the Check Button for 10
seconds. This will erase all pairing memory.
You may now pair new units to the receiver.
Alarm in Progress
When Transmitter comes in contact with water the Strobe Light on the Receiver activates and a Lound Alarm activates. As soon as gold pins are dry the device stops transmitting, however the Receiver Alarm will continue to sound alarm. To reset the Receiver, press the Pair/Reset Button or the On/Off Button.
If On/Off Button is pressed the unit will be in off state and will no longer monitor.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IC WARNING
This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Customer Support
1-800-272-0170
www.lunasea.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>