LUNASEA LIGHTING LunaSafe 10W Qi LL63 Wireless Charge Pad User Manual
- June 6, 2024
- LUNASEA LIGHTING
Table of Contents
Charging Transmitter
Place safety device on wireless charge pad so it is in the center. You will see a green light show through the graphic indicating that the unit is charging. Most wireless charge pads have LED indicators showing when charging is taking place.
Locking Wrist Strap
After threading the nylon strap through the safety device and back through the locking connector, turn the locking button 90 degrees as shown using a coin or screwdriver.
Receiver/Alarm
Charging Receiver
Make sure the unit is fully charged by placing it standing up on a charging pad. Then wait until the Charging Light goes off.
Turn Receiver On
Momentarily press the On/off button to turn it on. Unit initializes and then Ready indicator blinks showing the unit is in normal operation.
Low Battery
When the battery becomes low the Low Bat Indicator will Blink. Place the unit on Charge Pad until the battery is fully charged. The charging light will then go off indicating full charge.
Pairing Receiver with Transmitter
Press and hold the Check Button for 5 seconds then simply press the Manual-On
button on the transmitter. You will see the Pairing indicator blink multiple
times showing the device has been paired. You can do this with up to 8
transmitters. To delete all pairing information, press and hold the Check
Button for 10 seconds. This will erase all pairing memory. You may now pair
new units to the receiver.
Each time you turn on your transmitter either in strobe or monitor you will
hear a conffrming beep from the receiver to assure you that they are working.
Alarm in Progress
When the Transmitter is placed in water the Strobe Light on the Transmitter
activates, the Strobe Light on the Receiver activates and a Lound Alarm on the
Receiver activates. To reset the Strobe on the Transmitter simply push the
Manual-On Button. The transmitter will need to be dry to reset. To reset the
Receiver, press the Pair/Reset Button or the On/Off Button.
If the On/Off Button is pressed the unit will not be in off state and will no
longer monitor.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
IC WARNING
This device contains license-exempt transmitter(s) that comply with
Innovation, Science, and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
www.lunasea.com
LL63 Instructions Rev 3
Documents / Resources
|
LUNASEA LIGHTING LunaSafe 10W Qi LL63 Wireless Charge
Pad
[pdf] User Manual
LLB-63XB, LLB63XB, 2A24X-LLB-63XB, 2A24XLLB63XB, LunaSafe 10W Qi LL63 Wireless
Charge Pad, LunaSafe 10W Qi LL63, Wireless Charge Pad
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>