SHINANOINC Kihn C-4900 Air Tool Instruction Manual

SHINANOINC Kahn  C-4900 Air Tool

Product Information

The product is a puncher designed for punching holes in various materials. It consists of several components including

• Arm head (x2)
• Punch guide (x2)
• Oil inlet
• Throttle lever
• Exhaust
• Air inlet

The puncher is available in two models:

• Model Number: SI-4900
• Model Number: SI-4910

INSTRUCTION MANUAL FOR PUNCHER

Accessories

• 4mm Allen Wrench
• Safety Instructions

Operation Procedures

1. Connect a coupler in the air inlet of the motor housing.  The arm head can rotate in the 360 degree range.
2. Pour approx. 5cc (2 to 3 drops) of the oil through the  installed coupler, and do idling run for 3 to 5 second.
3. Determine the position according to servicing points.
4. Pull the throttle lever, and the tool will operate. Release it  to stop thee operation.

Punching Work hole Position

Specifications

Model Number|

Parching Cap

| Cutting. cap mm/(in.)| Weight kg/(lb. )| Vibration m/s2| Ang  .Air Consumption CFM (L/S)
---|---|---|---|---|---
SI-4900| φ6.5×2| 1.0/(3/64)| 1.00/(2.20)| < 2.5| 1.3/(0.6)
SI-4910| φ5/φ6.5| 1.0/(3/64)| 1.00/(2.20)| < 2.5| 1.3/(0.6)

How to inject hydraulic oil

If the tool power is down during punching work the failure may almost cause due to oil shortage. Supply oil according to  the procedures as shown below.

1. First, remove the air hose.

2. Remove two screws at the oil inlet in  the head of the body, using the 3mm  Hex. wrench.
   Note To remove the screws, be careful not tomes  the O-ring.

3. Then, supply oil from either oil inlet so as to fill up the tank.
   Note Be sure to employ #30 to #40  hydraulic oil.

Caution for Operation

• The air tool is a very precious tool. Be careful not to drag or drop the air tool as much as possible.
• Avoid idling run of the air tool for a long time.
• Avoid overloading operation, because it is dangerous to use the air tool beyond the capability.
• Open the tool within the air pressure 0.63MPa(6.5/cm2).If operated in Hight pressure, the maximum  allowance speed will be exceeded, which may result in damage of components.

AIR SUPPLY

Model Number|

Parching  Cap

| Cutting. cap mm/(in.)| Weight kg/(lb.)| Vibration m/s2| Avg. Air Consumption CFM (L/S)
---|---|---|---|---|---
SI-4900| φ6.5×2| 1.0/(3/64)| 1.00/(2.20)| < 2.5| 1.3/(0.6)
SI-4910| φ5/φ6.5| 1.0/(3/64)| 1.00/(2.20)| < 2.5| 1.3/(0.6)

https://shinanoinc.com

References

• PNEUMATIC TOOLS SHINANO INC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>