SinG-e ZQSMIC Wireless Microphone Instruction Manual
- June 12, 2024
- SinG-e
Table of Contents
**SinG-e ZQSMIC Wireless Microphone Instruction Manual
**
Packing list
**microphone
**
Microphone product description
- Install the No.5 battery
- Press and hold to turn on the wireless microphone
- Turn on the main speaker
- The wireless microphone will automatically connect to the host computer (The green light is always on when the connection is successful.The green light flashes slowly if the connection is not successful)
- Turn on any wireless microphone, it can be automatically connected, two wireless microphones are turned on at the same time, automatic connection, both microphones can be used.
Product specification:
TX emission frequency: 2.402GHz-2.480GHz
Audio dynamic range ≥85 db
Audio Response: 20 Hz ~18 khz
Low Distortion: < 5%
Battery: No.5 battery
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>