COMPCOR 1692887508 Outdoor Table Tops Instruction Manual
- June 12, 2024
- COMPCOR
Table of Contents
COMPCOR 1692887508 Outdoor Table Tops
Product Information
The COMPCOR table is designed with a sturdy construction to provide a stable surface for various applications. The table top is machined to accommodate elevator bolts, which can be easily adjusted to align with holes in Oak Street spiders. The table base includes lock washers and nuts to securely fasten the table top to the spider. The table also features leveling glides for easy adjustment and stability.
Product Usage Instructions
- Place the table top face-down onto a non-damaging surface, such as cardboard.
- Insert the included elevator bolts, thread-side up, into the rails of the table top.
- Position the table base onto the table top so that all bolts in the table top go through the inner corner holes in the spider.
- Place the included lock washers and nuts onto the bolts, then tighten them until snug.
- Screw out the short bolt located at the bottom of the tube/spider.
- Attach the cross foot onto the tube.
- Using a socket set or crescent wrench, screw in the short bolt with the lock washer and flat washer into the tube.
- Place the disc foot on the tube.
- Locate the leveling glides and screw them into the welded end tabs of the foot.
Once you have completed these steps, your COMPCOR table will be assembled and ready for use. Make sure to check that all components are securely fastened before placing any items on the table.
ASSEMBLY INSTRUCTIONS
NOTE: All COMPCOR tops are machined to accommodate elevator bolts that are easily adjustable to align with holes in Oak Street spiders.
- Place table top face-down onto a non-damaging surface such as cardboard.
- Insert included elevator bolts, thread-side up, into rails.
- Place table base onto table top so all bolts in table top go through inner corner holes in spider. Put included lock washers & nuts onto bolts then tighten until snug.
- Screw out short bolt in bottom of tube/spider
- Place cross foot on tube Place disc foot on tube.
- Using socket set or crescent wrench, screw in short bolt with lock washer and flat washer into tube
- Locate leveling glides and screw into welded end tabs of foot.