HPEVA B096JWGZW7 Car Electronic Throttle Controller Instruction Manual

HPEVA B096JWGZW7 Car Electronic Throttle Controller Instruction Manual

Function And Specification

1. The product can improve the car handling ability by control the sensitivity of car throttle controller switch,and adapt to different driving habit and road conditions.
2. there are 5 Modes as below:
   • P1-Comfortable Mode
   • P2-Sports Mode
   • P3-Racing Mode
   • NOR-Normal Mode
   • EC-Fuel-efficient Mode
   • Except the Normal mode, all other modes have 9-level fine-tuning function
3. There are 9 levels ( 1-9) for the acceleration, the acceleration sense from weak to strong is very obvious, and not affect the throttle control capability. Please note: The factory default setting mode is P2.6
4. This product is suitable for all car models, gasoline, diesel, hybrid oil and electricity, or pure electricity.

Installation Instruction

1. Connect the Throttle Controller with the accelerator Pedal interface
2. Stick the Throttle Controller on central console
3. Connect the plug with the Throttle Controller ,bind

Step1 :
Pull away the interface of the accelerator pedal. Please refer to picture 1

Step2:
Connect the throttle controller cable plug with accelerator pedal interface .Please refer to picture2

Step3:
Tear the protection paper on the back of Throttle Controller, and stick it on the central console

Safety Precautions

1. 1.Before the installation, user need to check the Electronic Throttle Controller plug and accelerator pedal interface, they should be connect properly.
2. After finish installation, please start engine under the Neutral Gear or P Gear, and check the accelerator pedal is work.
3. If install the wrong direction, it will cause the accelerator pedal invalid and the warning light of engine will be on. If in this situation, please don’t worry, this products has the internal protection circuit, which will prevent harms to the vehicle parts. Please turn off the engine and disassemble this product. After 2minutes, install this product in the correct way, then it can work.

Operation

a. This product can be operated by the three keys ,from left to right, the buttons are ‘Mode’, ‘ －’, ‘＋’
b.The product can be adjusted at any time after power on, but please pay attention to driving safety when adjusting the product.
c.Press the mode button , it will show: P1-Comfortable Mode,P2-Sports Mode, P3-Racing Mode, NOR-Normal Mode ,EC-Fuel-efficient Mode
d. the two button can adjust the level of the mode from weak to strong, there are9levels(1-9),Please note: except the Nor-Original Mode ,all of above modes have 9 levels adjustment

Explanation for

| P1 Comfortable Mode
Accelerate the throttle response speed, start faster, smooth acceleration, optional 1-9 grade.(P1.9 means comfortable mode and 9 level)
---|---
| P2 Sport mode
Improve instant acceleration, improve cornering performance, and get the best speed-up effect.1-9 level to adjust from weak to strong(P2.9 means Sport Mode and 9 level)
| P3 Racing Mode
Achieve the Superior acceleration performance and make it feels like in the Racing-Field.1-9 level to adjust from weak to strong. (P3.9 means Sport Mode and 9 level)
| EC Fuel-efficient Mode
Achieve the best Fuel-efficient mode, about 3-8% fuel saving.
---|---

| NOR Normal Mode
Back to the Normal control mode.
| Automatic Mode
Long press”+” for 3 seconds, screen will show AAA ,it means enter into automatic mode
| Manual Mode
Long press “－” for 3 seconds, screen will show SSS, it means enter into manual mode

Troubleshooting

1. After the device is properly installed, the engine sound becomes loud and the accelerator pedaldoes not respond. Turn off the car, remove the key, and start again

2. The power is not obvious or does not respond after normal installation
   Device self-learning steps:

3. Connect the line when the car is powered off, and then power on the car but do not start it.

4. Long press the MODE button to enter the setting 8xx mode, and then adjust to 800 by the‘-’ or ‘+’ button.

5.  After the screen shows 800, then press the accelerator to the bottom and then release it

6. Long press the MODE button for more than 5 seconds. After the screen jumps out of  the800mode,the learning is successful.

7. RPM increased than before, engine fault light also turned on
   Remove the accelerator, then start the car seven or eight times. If the fault code has not been removed, it is recommended to use a diagnostic tester to eliminate it.

8. The accelerator cannot stop when the car runs at racing mode P3.1 to P3.9, and the accelerator pedal cannot be stopped. The racing mode has a very strong effect. We recommend do not use the racing mode, causeits effect is very strong, it also will increase the fuel consumption, and very hard to control. You must unplug it if out of control.

9. The feeling of engine shake in the 5th gearbox
   Check the mode first, if using P2.8 sports mode. You can adjust to P2.1, the effect is too strong and the gearbox cannot respond. (If you don’t feel the acceleration under P2.7, it is recommended to useP3.1)

10. After tried all modes, there will be a delay when the vehicle is accelerating rapidly, and if you change the mode during cruise, the RPM will not change. When accelerating quickly, the gearbox didn’t respond, so it has been stuck there without shifting; this is the car’s transmission reaction problem. Please

11. The competitive mode is similar to the original car mode
    Check the mode is wrong or not; remove it for a few days and re-install it. If the change is slow, you ,may get a fuel-saving mode. To avoid adjust wrong mode, it is recommended to read the letters on the manual and re-adjust adjust to comfortable mode, don’t speed up suddenly.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>