ring 3 Plus Two Way Video Doorbell User Guide
- June 12, 2024
- Ring
Table of Contents
VIDEO DOORBELL
Quick Install Guide
3 Plus Two Way Video Doorbell
With Ring, you’re always home.
FRONT
-
Wide Angle HD Camera
-
Microphone
-
LED Ring
-
Push Button
-
Speakers
BACK -
Setup Button
-
Micro USB Charging Port
-
MAC Address
MOUNTING BRACKET -
Doorbell Wire Terminals
-
Mounting Hooks
-
Wire Management Hooks
BATTERY CHARGING
Charge your device using a USB-compatible wall charger or laptop. To ensure
your device is fully charged, charge the device prior to Wi-Fi setup and
installation.
LED RING LIGHTING SEQUENCES
| Battery Charging | LED Ring spins blue, then white. | |
|---|---|---|
| Battery Charging Complete | LED Ring stays fully lit blue. | |
| Call Initiated | LED Ring spins blue. | |
| Call Connected | LED Ring stays fully lit blue. | |
| Hardwired | LED Ring stays dimly lit white. | |
| Setup Mode | LED Ring spins white. | |
| Software Update | LED Ring blinks white. | |
| Factory Reset | LED Ring blinks blue. |
WI-FI SETUP
Download the Ring app from the App Store Google Play or Windows Store. Open
the Ring app and select Setup Device. Follow the in-app instructions to set up
your Ring.
You will need your network information (SSID and password) to complete your
Ring setup.
INSTALLATION
-
Remove doorbell button and power off your transformer (for wired installation only).
-
Line up the mounting bracket using the provided mounting level.
-
Install the mounting bracket using the provided screwdriver bit, handle and drill bit.
Brick – use provided screws and anchors
Concrete – use provided screws and anchors
Stucco – use provided screws and anchors
Wood – use provided screws
Vinyl – use provided screws -
Remove the mounting level.
-
Connect your doorbell wiring to the terminal screws located on the mounting bracket (for wired installation only).
-
Place the device on the mounting bracket.
-
Tighten the security screws at the bottom of the device using the proprietary screwdriver bit. Please do not over-tighten the security screws.
-
Provide power back to your transformer (for wired installation only).
HARDWIRING REQUIREMENTS
If powering off doorbell wiring, the wiring must be connected to a transformer
and a doorbell with a voltage of 8VAC – 24VAC to ring your doorbell chime.
If your chime is electronic (e.g. plays a melody), you may need to install a
diode, which is commonly found inside your current doorbell button, or check
with your doorbell manufacturer.
Connect the diode to the terminals with the arrow on the diode facing towards
the doorbell chime as shown below.
ANSWERING A CALL
| Mute Volume
---|---
| Disable Microphone
| End Call
| Call Zoom
To disable notifications for your Ring device, select it from “My Devices”. Select “Device Settings” and toggle notifications off.
CUSTOMER SUPPORT
For additional product information and helpful tips, check out our support
forum at: http://ring.com/help
For immediate assistance, please call us at:
DOMESTIC: 1-800-656-1918
INTERNATIONAL: +1 310-929-7085
7 days a week
1523 26th St.
Santa Monica, CA 90404
Hereby, Bot Home Automation, declares that this consumer electronic is in
compliance with the essential requirements and other relevant provisions of
Directive 1999/5/EC. The declaration of conformity may be consulted at
www.ring.com/DoC.pdf.
Protect the device from direct sunlight. Install the device at dry locations
and protect it against rain and humidity. The device may not get contact to
salt water or other conductive liquids. The device must be charged only within
a building in a dry state.