Newland WD1 Smartwatch User Guide
- June 12, 2024
- Newland
Table of Contents
WD1
Watch Scanner
Charging the battery
Before your first use, please make sure the battery is fully charged via the included AC adapter and cable.
LED Status
Charging LED/ Battery status
| Blue LED on | Fully charged |
|---|---|
| Red LED on | Charging in progress |
| Red LED flashes | Low-battery alert |
Appearance
Quick settings
Power key
- When the terminal is powered off, hold down the power key for 3 seconds to switch the terminal on.
- When the terminal is powered on, briefly press the power key to lock the screen.
User-defined key
- The user-defined key will be set as “Home Key” by default.
- To reset the user-defined key: go to “Quick Setting” > “Key Map”, then set the parameters per your needs.
Touch the screen
- Back to previous page: swipe inward from the left or right edge of the screen.
- Back to the desktop: swipe the screen from bottom to top.
- Switch to new task: swipe the screen from bottom to top, then hold on until the recently used apps display.
Installing the SIM Card
- Pull the tray out from the slot then place the SIM card in it.
- Gently push the tray back into the slot until it locks into place.
Remark: Please install the SIM Card with its metal contacts facing towards the screen to avoid damage.
Safety guidelines
-
Do not charge the device in a hot or humid environment.
The temperature will affect the charging efficiency. -
The terminal contains a built-in battery. Please do not try to replace it yourself in order to avoid damage.
-
Do not use the terminal’s wireless functionalities where wireless device use is prohibited or where is may cause interference or danger, such as in mines or gas stations.
-
Use only a dry, soft cloth to clean the terminal. Cleaning with a wet cloth or other chemical cleaners may deform and shorten the service life of the keypad and shell of the terminal.
-
The temperature should not be too low or high during use. This could cause malfunction. Please use the terminal under the permitted temperature.
-
If the terminal is damaged due to a drop or water, contact the service center. Do not try to repair it yourself.
Support Information
For more information and technical support, please visit
WD1
Name: WD1-NW10 Watch Scanner
Manufacturer: Newland EMEA
All technical information are subject to the actual performance, Newland
reserve the right of final explanations.
PN:1060090482
Newland Europe BV
Rolweg 25
4104 AV Culemborg
The Netherlands
BSR id ware Gmbh
Jakob-Haringer-Str.3
A-5020 Salzburg
https://www.bsr.at
sales@bsr.at
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>