ambience Lighting Andro Trim Adjustable Recessed Light Installation Guide

ambience Lighting Andro Trim Adjustable Recessed Light

Everything you wanted to know but were too afraid to ask

WHOA, HOLD IT!

1. To avoid non-replaceable damage of custom painted fittings, the secondary ring must be removed before adjusting the inner tube.
   The inner tube must be adjusted at ground level before ceiling installation.

2. Hit the off switch on any power before install.

3. Install must only be carried out by someone suitably qualified.

4. Only use the product at the specified voltage and frequency.

5. It would be sweet if you the packaging.

6. Read Step 1 again. Thx.

INSTALLATION INSTRUCTIONS

1. Cut a hole in the ceiling as per the nominated cut-out sizes:
   S Ø98mm
   M Ø115mm
   L Ø128mm

2. Remove the secondary ring by rotating it anti-clockwise and pulling it out.

3. Push the housing in the hole.

4. A Fix the screws onto the ceiling using a screw driver.
   
   4B Tighten the screws until the flanges on the housing are retracted and the housing is held tight in its position.

5. Fix the secondary ring back onto the housing by rotating it clockwise and pushing it in.
   

6. Turn ON power supply to complete installation.

7. Now repurpose your andro packaging to plant some seedlings.

CUSTOMER SERVICES

+61 3 9486 3699
sales@ambiencelighting.com.au
ambiencelighting.com.au

References

• ambience | Lighting Design & Architectural Lighting Supply | Making Light Work

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>