ProLoisir B07NHR8D78 Aluminum Cantilever Parasol Instruction Manual
- June 12, 2024
- ProLoisir
Table of Contents
ProLoisir B07NHR8D78 Aluminum Cantilever Parasol
Product Information: Product Name: Unknown (not mentioned in the text) Manufacturer: Unknown (not mentioned in the text) Model Number: Unknown (not mentioned in the text) Country of Origin: France Address: 19 Rue de Bordeaux 17800 PONS-FRANCE Product Usage Instructions: 1. Before starting the assembly process, it is recommended to refer to the assembling advice in the annex section of the user manual. 2. The product consists of several components, as described below: – Top Cap: This is the top part of the product. – Hub: This component is not described in detail. – Runner: This component is not described in detail. – Ring: This is a circular ring. – Corner Ribs (Upper & Lower Ribs): These are ribs located at the corners of the product. – Side Ribs (Upper & Lower Ribs): These are ribs located on the sides of the product. – Pole’s Top: The top part of the pole. – Sliding Handle (Rope included): A handle that can slide and comes with a rope. – Tilt Handle: A handle for tilting the product. – Pole’s Screw: A screw used for attaching the pole. Cross Base: A base in a cross shape.
Rotating Cap: A cap used for rotating. Rotating: This component is not
described in detail. Base 8-Screw Set (with Washers): A set of 8 screws with
washers for attaching the base. Start assembling the product by following
these steps: a. Gather all the components mentioned above. b. Identify the
correct positioning and orientation of each component based on the provided
description. Use the screws and washers from the Base 8-Screw Set to attach
the base to the desired surface. d. Attach the pole’s top to the base using
the pole’s screw. e. Attach the corner and side ribs to the pole’s top
according to their designated locations. Place the ring on top of the
assembled ribs. Attach the sliding handle to the designated location,
ensuring that the rope is properly secured. Attach the tilt handle to its
designated location. Finally, place the rotating cap on top of the assembled
components. Once the assembly is complete, ensure that all the components are
securely attached and tightened.
Note : The specific assembly steps may vary depending on the product
model and design. Please refer to the complete user manual for detailed
instructions specific to your product model.
ASSEMBLING INSTRUCTIONS
TOOLS REQUIRED
INSTALLATION
BEFORE STARTING, REFER TO THE ASSEMBLING ADVICE IN ANNEX
ASSEMBLY ADVICE
- CAREFULLY READ THE ASSEMBLY INSTRUCTION.
- IDENTIFY THE COMPONENTS OF THE FURNITURE.
- GROUP AND CHECK THE HARDWARE.
- USE THE REQUIRED TOOLS.
- CREATE AN ASSEMBLY ZONE.
- MAKE THE ASSEMBLY.
CLEANING ADVICE
- CAREFULLY REMOVE THE DUST.
- USE A SOFT. CLEAN DAMP CLOTH WITH SOAPY WATER
NEVER USE ABRASIVE PRODUCTS OR SOLVENTS. DO NOT APPLY EXCESSIVE PRESSURE WHEN USING THE DAMP CLOTH.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>