IC HOME GUARDI 2MP 1080P Indoor WiFi Security Camera User Guide
- June 12, 2024
- IC HOME
Table of Contents
GUARD!
Quick Start Guide
What’s in the Box
Know your Guardi
Note: Press & hold the reset button fpr 30s until you hear the audible prompt. The pattern of the LED indicator is included in the following table.
LED Indicator Status | Device Status |
---|
Off
| • Powered off/LED turned off
• Rebooting after reset
Red light on| • Booting
• Device malfunction
Green light flashing| Waiting for network
Green light on| Operating properly
Red light flashing| Network connection failed
Green and Red light flashing alternately| Firmware updating
Using IC Home
Step 1
Scan the QR code or search “IC Real time” in the Google Play or App Store to download & install.
Step 2
Pun the App, and then register a new account if you do not already have one.
Step 3
Connect the camera to a power source.
Step 4
The camera LED indicator will flash green when it is fully booted on.
Step 5
With your mobile device connected to a 2.4 GHz WiFi band, follow the steps on the app to add a camera.
Note:
- Repeat step 5 for adding multiple cameras.
- If camera fails to to add or the WiFi connection is changed. Reset the camera and repeat step S.
Camera Installation
Note: Make sure that the mounting surface can hold at least 11b.
Step 1 Use the guide to mark & drill holes for the drywall anchors.
Step 2 Attach the mounting plate by drilling the provided screws into the anchors from step 1.
Step 3 Attach the camera to the magnetic mounting plate, and adjust lens as needed.
About the Guide
- This quick start guide is for reference only. Minor differences may be found in the user interface
- All the design and software here are subject to change without prior written notice.
- All trademarks & registered trademarks mentioned are the properties of their respective owners.
- Please visit our website or contact your local service engineer for more information.
- If there is any uncertainty or controversy, please refer to our final explanation.