SCHWAIGER ZA100 Indoor Aerial User Guide
- June 12, 2024
- Schwaiger
Table of Contents
SCHWAIGER ZA100 Indoor Aerial
Product Information
The ZA100 Indoor Aerial is a device used for receiving VHF (174 230 MHz) and
UHF (470 -790 MHz) signals. It comes with a plug-in power supply, with a
voltage range of 100-240 V. The aerial has a coaxial cable for connection and
requires a 5V power supply with a current of 50 mA. The package includes the
aerial itself and an instruction manual.
Technical Specifications
- Frequency Range: VHF (174 – 230 MHz), UHF (470 -790 MHz)
- Impedance: Not specified
- Coaxial Cable: Included
- Receiver/TV Connection: Requires external power supply unit
- Electrical Connection: 5V, 50 mA
Optimum Location for the Indoor Aerial
To ensure optimum reception, it is recommended to place the indoor aerial in a
location with as few obstacles as possible that may block the signal between
the transmitter and the aerial. Placing the aerial near a window is often the
best position. Use the signal strength indicator on your DVB-T(2) receiver to
find the best aerial position. Test different positions and signal directions
before finalizing the placement.
Product Usage Instructions
Connecting the Indoor Aerial for TV Sets with Integrated DVB-T(2) Receiver:
- Make sure that the DVB-T(2) receiver is turned off.
- Connect the coaxial cable of the indoor aerial to the TV set’s DVB-T(2) receiver. Use the left or right connection example depending on your setup.
- If necessary, use an external amplifier for better signal quality.
- Connect the external power supply unit to the TV set.
- Receiving VHF Signals (174-230 MHz, DAB+)
If you want to receive VHF signals, extend the telescopic rods on the aerial and adjust them until you achieve optimal reception.
Safety Instructions
- Only use the aerial for its intended purpose.
- Avoid exposing the product to cleaning agents and make sure no water or moisture gets into the product.
INTRODUCTION
Congratulations and thank you for purchasing this ZA100 011 indoor aerial. This user guide is designed to help you use and operate the device. Read through the User guide carefully. Store this manual safely throughout the product‘s entire service life and pass it on to any subsequent users or owners. Check that the supplied package is complete and ensure that none of the parts are defective or damaged. All devices that we distribute comply with the safety regulations valid at the time of purchase, and are safe provided they are used for the intended purpose. For simplicity, the ZA100 011 indoor aerial is referred to as „indoor aerial“ in this guide
How to use this aerial
The indoor aerial is used to receive digital television and radio programs. It must not be used for any other purpose!
Safety instructions
- Please use a suitable power supply unit (see Technical Data). Make sure the polarity is correct.
- This indoor aerial is an electronic product that must be kept away from children!
- Therefore, keep it out of the reach of children.
- The indoor aerial should only be used in interior rooms.
- Do not use the indoor aerial in wet/damp rooms or in the open air.
- Do not introduce any objects into the product’s connections or openings
- Have the indoor aerial repaired by a technician if it is defective?
- Disconnect the power plug before cleaning.
- Clean this indoor aerial only using a lint-free, damp cloth that is as light as possible, and do not use any aggressive cleaning agents. In doing this, especially ensure that no water (no fluid or moisture) gets into the product.
Verpackungsinhalt
- Indoor aerial (UHF / VHF) with 1.5 m connection cable
- Plug-in power supply 100-240 V / 5.0 V 550 mA, 2.75 W
- Radio (IEC) adapter
- User guide with Safety instructions
OPTIMUM LOCATION FOR THE INDOOR AERIAL
You should ensure that there are as few obstacles as possible that may block
the signal between the transmitter and the indoor aerial to guarantee optimum
reception. The best position to place the indoor aerial is often near the
window. DVB-T(2) receivers often have a signal strength indicator. This
indicator will help you find the best aerial position. Check different
positions and signal directions before you finally site the aerial If you wish
to receive VHF signals (174-230 MHz, DAB+), extend the telescopic rods and
adjust until you achieve optimal reception.
CONNECTING THE INDOOR AERIAL FOR TV SETS WITH INTEGRATED
DVB-T(2) RECEIVER
CONNECTING THE INDOOR AERIAL FOR TV SETS WITHOUT INTEGRATED
DVB-T(2) RECEIVE R
CONNECTING THE INDOOR AERIAL FOR DAB+ RADIOS
Connection example
- Make sure that the DAB+ radio is switched off.
- Connect the coaxial cable of the indoor aerial to the aerial connection of the external amplifier.
- Now plug the cable of the external power supply unit into the 5 V DC socket of the external amplifier and the external power supply unit into a 230 V AC socket.
- Plug the IEC connector provided (radio IEC connector) onto the coaxial cable of the external amplifier and then connect the coaxial cable to the aerial input of your DAB+ radio
- You can now look for channels that you can receive. If necessary, refer to the DAB+ radio user manual for guidance.
Disposal
Do not dispose of batteries or electric and electronic devices in normal household waste. The consumer is legally obliged to return electrical and electronic devices and batteries that are at the end of their useful life to the point of sale or public collection points that have been set up for this purpose. Legislation in the country of use governs individual details regarding disposal. The symbol on the product, the user guide or the packaging indicates this legal requirement.
Disclaimer
Schwaiger GmbH does not accept any liability or warranty for damages that are
sustained due to improper installation or mounting, improper use of the
product or non-compliance with the safety instructions.
Manufacturer‘s information
Dear Customer, Please contact our Technical Support if you need technical
advice and your retailer is unable to help you. Simplified declaration of
conformity as per the RED Directive Schwaiger GmbH hereby declares that the
radio system type complies with Directive 2014/53/EU. The complete EU
declaration of conformity is available online at:
https://download.schwaiger.de
Office hours: Monday to Friday: 8:00 a.m. – 5:00 p.m.
Schwaiger GmbH
Würzburger Straße 17 | 90579 Langenzenn
Direct line: +49 (0) 9101 702-299
www.schwaiger.de |
[email protected]