Dulux SPLASHBACK Renovation Range Tiles and Benchtops User Guide

Dulux SPLASHBACK Renovation Range Tiles and Benchtops

Product Information

The Dulux Renovation Range Splashback is a three-step system designed to transform and protect your tiles and benchtops. It includes a primer, topcoat, and clear coat for a durable and long-lasting finish. The range offers a variety of colors,
including the popular Dulux Cardrona shade. The clear coat is available in both satin and gloss finishes to suit your preference. The product is easy to use and provides a smooth, consistent finish.

Product Usage Instructions

1. Preparation: Ensure the surface is clean and free from grease and dirt. Use a mild cleaning detergent and avoid abrasive cleaners.
2. Mixing: For both the primer and topcoat, add all of the additive underneath each lid to each product. Stir well for approximately 2-5 minutes using a broad flat paddle until the additive is completely mixed into the paint. The mixed product can be used for up to 10 days.
3. Application – Primer: Apply 1 coat of Dulux Renovation Range Primer to the surface following the instructions on the pack. Allow it to fully dry for 8 hours before proceeding.
4. Application – Topcoat: Use a quality angled sash cutter brush to cut in around edges. Then, coat the surface using a 4mm nap 100mm wide microfibre roller. Once each section is coated, gently go over the surface in the same direction with an unloaded roller using minimal pressure to achieve a smooth finish.
5. Application – Clear Coat: For benchtop and splashback areas, apply Dulux Renovation Range Clear Coat as the final coating. This will provide added protection to the topcoat. Choose between satin and gloss finishes based on your preference.
6. Additional Steps: Sand the surface and scrub the tiles before starting the application process. These steps ensure a clean and properly prepared surface for optimal adhesion.
7. For More Information: Visit the Dulux website for full use instructions, data sheets, application tips, and FAQs. You can also contact the customer support team via phone or online chat for help and advice.

Note : The Dulux Renovation Range Floor product does not require a clear coat as it may affect the non-slip performance.

SPLASHBACK

Dulux® Renovation Range Tiles & Benchtops is a revolutionary, water based interior coating perfect for transforming your splashback.

Shopping List

• Dulux® Renovation Range Tiles & Benchtops in your chosen colour
• Dulux® Renovation Range Clear Coat
• Dulux® Renovation Range Primer
• 38–50mm high quality angled sash cutter
• 4mm nap 100mm wide microfibre roller
• Paint stirrer and drop sheet
• Painters tape
• P400 sanding paper
• Selleys® Sugar Soap
• Selleys® Silicone Remover
• Selleys® Rapid Mould Killer™
• Dulux® Renovation Range Grout Pen – optional

EXPERT TIP
Use the Dulux Renovation Range Grout Pen to recreate the look of grout lines after you’ve painted.

Preparation

Dulux Renovation Range Tiles & Benchtops requires a clean surface to adhere. All grease and dirt contamination MUST be removed, or the paint will not adhere and will peel or flake off.

Previously Painted Surfaces:
On ALL surfaces cleaning is the most important step.

• Scrub down all areas with Selleys® Sugar Soap and rinse with clean water to remove any dirt, oil or grease. Use a plastic scouring pad on heavily contaminated surfaces.

• Repeat this process using clean water, at least twice.
  IMPORTANT : Do not use abrasive cleaning detergents.

• Completely remove any loose and flaking paint. Fill any cracks or holes with a suitable hard epoxy based filler such as Selleys® Knead-IT® Aqua.

• Sand glossy and semi gloss finishes to a dull flat finish using p400 paper before coating.

• Use a clean damp cloth to remove any dust.
  Tiles and Glass – Wall and Splashback:

• For grout lines ensure to remove all grease and oil.

• Thoroughly clean surface using Selleys® Rapid Mould Killer™. Remove all silicone sealant from joints using Selleys® Silicone Remover.

• Wash down well with water.

• Sand with p400 paper all areas where silicone has been removed.

• Wash with Selleys® Sugar Soap and use a scrubbing brush or a toothbrush to properly clean grout lines.

• Rinse with clean water and dry with a clean cloth.

• Allow grout lines to dry for a minimum 2 hours before painting. Mask using a good quality painters tape.

Mixing

• For both primer and topcoat, add all of the additive underneath each lid to each product.
• Stir well for approximately 2-5 minutes with a broad flat paddle, using an up and down scooping action until the additive is completely mixed into the paint.
• Once mixed the product is suitable to use for up to 10 days.

Application

Primer
Apply 1 coat of Dulux Renovation Range Primer to the surface following the instructions on pack, and allow to fully dry for 8 hours before applying your topcoat.

Topcoat
After the additive has been added and stirred, apply at least two coats of Dulux Renovation Range Tiles & Benchtops ensuring that the previous coat is left for a minimum of 8 hours before recoating.

1. Cut in as necessary using a 38–50mm high quality angled sash cutter brush.
2. Coat surface using a 4mm nap 100mm wide microfibre roller.
3. Lay off. Once each section is coated, gently go over the surface in the same direction with an unloaded roller using minimal pressure. This will give a smooth consistent finish.

Clear Coat
On benchtop and splashback areas apply Dulux Renovation Range Clear Coat as the final coating. This will add a layer of protection to the Dulux Renovation Range topcoat.

Check out the video at dulux.co.nz/paint/renovation- range

THE PERFECT RENOVATION SYSTEM

This revolutionary range works as a three step system. For the best possible result, ensure you always follow all three steps.*

1. CLEAN & PREP
2. TOPCOAT
3. FINAL TOUCHES

NEED HELP & ADVICE?

CALL: NZ 0800 800 424
ONLINE & LIVE CHAT: dulux.co.nz

For ‘How To’ videos, helpful tips and more,  scan here!

FRONT COVER : Tiles: Dulux Renovation Range Tiles & Benchtops in Dulux Cardrona.
Cupboards : Dulux Renovation Range Cabinet Doors in Dulux Ōpononi.
Disclaimers : Colours shown are as close as possible to actual paint colours. Please note, due to limitations of the printing process, photographic and printed images may not represent the true colour. Always confirm your choice with a Dulux Sample Pot.
*For full-use instructions please see the Dulux website and review the Data Sheet, Application and FAQ information. †The Dulux Renovation Range Floor product does not require a clear coat as it will reduce the non-slip performance.
Registered trade mark information: Dulux, Worth doing, worth Dulux, Selleys and Knead-IT are registered trade marks and Rapid Mould Killer is a trade mark of DuluxGroup (Australia) Pty Ltd.

References

• Dulux Paint | The Colours of New Zealand®
• Dulux Renovation Range | Dulux

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>