sammic TM-5 Milk Heaters Instruction Manual

: June 12, 2024
: sammic

Table of Contents

OPERATION GUIDE
WARNINGS
Instruction For Use
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

sammic TM-5 Milk Heaters

OPERATION GUIDE

Position the latch so that the panel show “open” and remove the deposit milk. Clean the water tanks and milk using the cleaning device.
Fill the water tank with water.
Put the milk container back in the internal water tank, and turn it until “close” is displayed on the panel. During these operations, in the warehouse of milk a little water will enter from the internal water tank. remove all this water using the milk tap before filling the milk tank with milk. Thanks to the milk container has an O-ring around the connector to prevent leakage, no more water will enter the milk tank from the internal water tank Once this water is removed. Put the milk container in its place and quickly lock it to prevent it from entering more water in the tank.
Fill the milk container with milk and replace the lid.
Turn on the machine. place the switch in 1″. The indicator will light up and the machine will start to work. When the temperature reaches 60-65ºC, the power will be will automatically deactivate. If the temperature drops to 50-55ºC, the power will turn on automatically. The machine is controlled by a thermostat to keep the milk at a temperature between 55 and 65ºC.
Place the cup on the collection tray and express the milk through the milk valve.
Make sure the switch is set to “0” and unplug the machine if it is not going to work. to use for a long period of time.

WARNINGS

Consult these instructions before using machine. This machine must be connected to an adequate power source and should be grounded.
Place the machine on a surface flat and stable in a well-ventilated area. Avoid placing the machine near products flammable and explosive.
Caution: the internal reservoir must be filled with water before starting the machine. The water level should be 5 cm above the heater. If the machine used for an extended period of time, water should be added.
The milk container must be positioned and locked according to the symbols shown on the panel. Otherwise, the deposit will not it will fit snugly and water will enter the milk tank.
Make sure that all the milk from the tank before cleaning and moving The deposit. Otherwise, the residual milk will enter the water tank during the removal of the milk tank.
To protect the unit and avoid injury, make sure not to over-wet the reservoir during cleaning. You can clean it with a cotton cloth moistened with water with detergent, and dry it with a clean cloth.
To avoid injury, the power cord damaged must be replaced by the manufacturer or by an authorized maintenance technician.
There are few accessories that can be directly replaced by the user. Yeah there is a problem with them, please contact contact the manufacturer and/or a technician authorized maintenance.
This appliance has been designed for use commercial and should be used only in interiors.
The apparatus is thermo-positive during operation, especially the casing metallic. Keep away from the appliance children and the elderly and be careful not to touch the casing when the appliance is in functioning.
Set the switch back to “0”, turn off the power supply, make sure that there is no milk left and clean the tank and the defrost tray. perform these operations after each use of the machine.
This appliance is not intended to be worn by persons (including children) whose physical, sensory or mental capacities are reduced, or lack experience or knowledge, unless they have had supervision or instructions regarding use of the appliance by a responsible person of your safety
If the power cord deteriorates and is I need to install a new one, said replacement It can only be carried out by a technical service recognized by SAMMIC.
CAUTION: In order to avoid a risk due to an inadvertent reset of the thermal fuse, the power to this appliance
must not be supplied via an external switching device, such as a timer, nor should the appliance be connected to a circuit that is regularly turned on and off by the system.