SelectBlinds BF-305A Remote Motorized Zebra Shades Installation Guide
- June 12, 2024
- SelectBlinds
Table of Contents
BF-305A Remote Motorized Zebra Shades
Installation Guide Installation Guide
Motorized Zebra Shades
SelectBlinds BF-305A Remote Motorized Zebra Shades
Fitting the shade
The brackets offer two methods of installation:
Top-Fixing
Use the front two holes in the top of the bracket to fix to the lintel (the
‘ceiling’ of the recess).
Face-Fixing 
Use two screws through the back
plate to mount onto a facing surface (a wall or window frame) 
Note that the position of the outermost brackets should be at least 5cm away
from the ends of the rail, with any other brackets evenly distributed across
the width.
Holding the rail at an angle,
situatethe T-shaped lip on the top of the cassette into the front lip of the
bracket.
Twist the back of the cassette
upwards until it snaps into place against the back lip of the bracket.
Remote BF-305A
Programming Instructions
-
Adjust switch on BY or BF working mode
BY mode: Short press UP or DOWN button motor in jog rotating, long press UP or DOWN button over 2 seconds motor will rolling up or down continuously.
BF mode: Short press UP or DOWN button motor will rolling UP or DOWN continuously -
Select the Channel for Programming:
Press “CHANNEL+” or “CHANNEL-” to choose the channel until the LED bright on the channel you want. -
Programming this channel on the Motor or Receiver:
Let the motor or receiver under the programming state ( operating according.to the instructions of the motor or receiver) -
Then press the CONFIRM key on the remote
( do it in 6 seconds after the motor under the programming state), the motor jogs, beeps or the receiver beeps to confirm the programming succeed.
FIY: The group channel will be recorded on the motor automatically when
the single channel has been programmed on the motor.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>