GoYeel ZF002WH LED Indoor Flush Mount Smart Fandelier Ceiling Fan Instruction Manual
- June 12, 2024
- GoYeel
Table of Contents
GoYeel ZF002WH LED Indoor Flush Mount Smart Fandelier Ceiling Fan
Product Information
The product is a ceiling fan with various features such as light on/off control, fan off control, color temperature control, light brightness control, fan rotation direction control, fan speed control, night light function, timing function, and pair code setup.
Product Usage Instructions
To use the product, follow the steps below:
- Turn on/off the light by pressing the light on/off button.
- Turn off the fan by pressing the fan off button.
- Adjust the color temperature of the light by using the color temperature control.
- Control the brightness of the light by using the light brightness control.
- Change the direction of the fan rotation by using the fan rotates forward/reverse button.
- Adjust the fan speed using the fan speeds control.
- Turn off all functions by pressing the all off button.
- Set up a pair code for the product by following the pair code setup instructions.
- Control the color temperature of the light by using the color temperature control.
- Enable the night light function for a specific duration by setting the timing for 1/2 hour.
- Connect a 5V power source to the product using the provided cable.
- Use the setup function to configure additional settings.
- Adjust the color temperature of the light by using the color temperature control.
- Control various functions of the product by using the provided buttons and controls.
Note: Refer to the user manual for detailed instructions and information on each function and control.
Installation steps
- Step 1: Disassemble the hanging plate of the lamp, then the hole position of the hanging plate is measured and located on the ceiling by borrowing the hole position of the hanging plate.
- Step 2: Punch holes in the positioning mark according to the size of the expansion screw, then hammer the expansion screw into the hole with a hammer (leaving one centimeter outside) and then counterclockwise unscrew the nut and meson to lock the hanging plate. (If your ceiling is not concrete but a wooden suspended ceiling, use self-tapping screws directly to secure the cross-hanging panels).
- Step 3: Install the hanging plate on the ceiling with the washers respectively. Ensure that the mounting plate is connected with the ceiling firmly, and ensure that the hanging plate and the expansion screw are sufficient to bear the weight of the lamp body.
- Step 4: The main line of the lamp body shuld be checked if the lamp works normally or not by connect 110-220V power supply. It is recommended that a professional electrician install the lamp.
- Step 5: Install the lamp hub on the hanging plate according to the hole position. please ensure that the lamp body and ceiling are securely connected.
Attention
- Please read the assembly drawing carefully before installing and maintaining the lamps and lanterns, and keep it properly for future use after use.
- The power supply used should not exceed the specified range of voltage (rated voltage AC110-220V) for a long time or may cause damage to the lamp overheating.
- Please pay attention to check whether the cable and switch are in good condition before use, and ensure that the local voltage is consistent with the lamp voltage.
- Please turn off the power before installing the lamp.
- Do not install the lamp above the high-temperature object, such as a stove, gas, exhaust, cylinder, etc., which may damage the lamp.
- Please do not refit the lamps, which may case of malfunction.
- Please clean and check regularly. Turn off the power before cleaning. Wipe the surface with a dry rubbing cloth. Do not wipe with acidic or alkaline chemical solvents, which will cause serious damage to the surface.
Installation
Turn on the power switch and press the ‘SETUP’ button within 2 seconds after
hearing the ‘drip’.The receiver beeps out two clicks, successfully matching
the code.
Tips: Before installation, the lamp should be tested for electricity. The
lampcan be installed to the ceiling only in normal operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>