nVent ECM19TP2U Tie Down Panel Instruction Manual
- June 12, 2024
- nVent
Table of Contents
nVent ECM19TP2U Tie Down Panel
Product Information
The Tie-Down Panel is a mounting accessory designed to secure cables and wires in a rack or cabinet. It is compatible with both open frame rack mounting and cabinet mounting.
The package includes:
- 1 Tie-Down Panel
- 4 12-24x.625 screws
- 4 10-32x.625 screws
- 5 additional screws (type not specified)
Please note that the type of screws provided may vary based on the rack angle
thread pattern.
Revision: B
Part Numbers: 87791233, 87791495
Product Usage Instructions
- Identify the appropriate mounting location in the rack or cabinet.
- If using an open frame rack, use the 12-24x.625 screws to secure the Tie-Down Panel. If using a cabinet, use the 10-32x.625 screws.
- Insert the selected screws through the holes on the Tie-Down Panel and align them with the corresponding holes on the rack or cabinet.
- Tighten the screws using a suitable screwdriver or tool until the Tie-Down Panel is securely attached.
- If additional screws are required, use them to reinforce the mounting.
Ensure that the Tie-Down Panel is properly installed and tightened to prevent
any movement or loosening during usage. Refer to the specific rack or cabinet
manual for further instructions on cable management and organization.
Note: Select screws to match rack angle thread pattern, typically 12−24
screws for open frame rack mounting or 10−32 screws for cabinet mounting. Only
one type of screw may be supplied.
© 2018 Hoffman Enclosures Inc.
PH 763 422 2211
nVent.com/HOFFMAN
P/N 87791233