Dana TST1C Intelligent Tennis Trainer User Manual
- June 12, 2024
- Dana
Table of Contents
Dana TST1C Intelligent Tennis Trainer
- Please read the instruction carefully before installing and using the product
- Please observe the warings and precautions marked in the product manual
Product components
Product parameter
Inventory
- Dana intelligent tennis trainer x1
- Remote battery x2
- Product manual x1
- Remote x1
- Power charger x1
How to use the equipment
Start up
- Turn on the power button, as shown below:
Remote control
Mobile control
- Scan QR code, then install APP.
- Turn on the phone’s Bluetooth and Internet connection, then as you see the bluetooth connection page, after the equipment is successfully connected, you can enter the training mode.
Enter the training mode
- Three training modes are available for users to select
For all modes:
Users can adjust the ball frequency（0-10）、speed(20-140km/h)、angle(-10-10)、
topspin or backspin（-10-10）.
Exception handling
matters need attention
- It is prohibited to use equipment when tennis court is watery or it is rainy, wet ball may cause stuck.
- To avoid injury do not stand in front of the ball outlet while the machine is running.
- If the ball is driven into the machine accidentally turn off the power and then take the ball out.
- Be sure to turn off power while cleaning the equipment, otherwise it may cause in danger.
- Periodically clean the debris inside the equipment.
- It needs to be charged in time the battery life will be affected if it is not charged for a long time.
- Please be sure to observe the precautions specified in this manual and use the product correctly. Otherwise the failure or loss caused by your improper use will not be covered by the manufacturer’s warranty the manufacturer does not assume any relevant responsibility.
Note: If you disassemble the equipment by yourself, all consequences are at your own risk.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference e to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or replace the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different f rom that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>